Search tips
Showing 132 results View by: Thread Post Sort by
    Answered

  • CC113L: CC113L/MSPM0

    Resolved
    Part Number: CC113L Hi, I'm currently working with CC113L+MSPM0. I have successfully received data from the transmitter in SmartRF, but unfortunately, I haven't received proper data from SPI. I have attached the analyzer screen herewith for your reference…
    • Resolved
    • Answered

  • CC113L: SmartRF Studio bug on reserved byte

    Resolved
    Part Number: CC113L Other Parts Discussed in Thread: CC110L , CC115L Tool/software: Hello, I'm working with CC113L, I noticed that it seems to be some errors between the CC113L documentation and SmartRF Studio on the values ​​of the reserved bytes of…
    • Resolved

  • CC113L: Keeloq receiver low range

    Part Number: CC113L Other Parts Discussed in Thread: TEST2 , CC1101 Tool/software: I'm using the CC113L with an own prototipe as a Keelog receiver for 868.35 MHz band. Following the design note DN022, a post in the forum about receiver for keelog and…
    • Answered

  • CC113L: Errata Note : Behaviour when FIFO contains more than one byte

    Resolved
    Part Number: CC113L Tool/software: Hello, Concerning the errata note https://www.ti.com/lit/swrz038 : "If a received data byte is written to the RX FIFO at the exact same time as the last byte in the RX FIFO is read over the SPI interface, the RX…
    • Resolved

  • CC113L: The CC113L chip receives abnormal

    Part Number: CC113L Other Parts Discussed in Thread: CC115L hi Ti engineer Recently, one CC113L chip was found to be abnormal, which was mainly manifested as serious packet loss. The preliminary analysis showed that the chip had to wait for a long time…

  • CC113L: CC115L/CC113L

    TI Thinks Resolved
    Part Number: CC113L Other Parts Discussed in Thread: CC115L , , CC1310 HI All, I am currently working on communication between one of our legacy devices and the CC113L (RX) and CC115L (TX) modules. Initially, I connected the devices using CC Debugger…
    • Answered

  • CC113L: The eeset function of CC113L

    Resolved
    Part Number: CC113L Other Parts Discussed in Thread: CC1101 Hi, I have a question regarding the reset function of CC113L. When using our equipment, the correct data may not be output even if data is received. Since random signals are occurring at the…
    • Resolved

  • CC113L: Request a set of configuration parameters

    TI Thinks Resolved
    Part Number: CC113L Other Parts Discussed in Thread: CC110L Tool/software: Hello My requirement: Based on the provided radio frequency parameters, request a screenshot of the configuration parameters on the Smartrf studio software and the exported parameters…
    • Answered

  • CC113L: How to set the number of premble bytes

    Resolved
    Part Number: CC113L Tool/software: How to set the number of premble bytes? I didn't see this configuration in the register in the manual. Best regards, HuangChaoyu
    • Resolved
    • Answered

  • CC113L: How to trigger an interrupt when receiving variable-length packets without length byte in the first position?

    Resolved
    Part Number: CC113L Tool/software: Hello, I am working with the CC113L . My use case is the following: The RF frames I receive have different lengths . The length of the frame is not included in the first byte (so I cannot use the "variable…
    • Resolved

Didn't find what you are looking for? Post a new question.