Part Number: CC1310 Hi Team,
I am working on CC1310 and have developed a temperature sensor task in Sensor Controller Studio (SCS) . The task runs correctly in SCS, and I am able to observe accurate temperature readings based on environmental changes…
Part Number: CC1310 Hello,
can an external TCXO(Temperature Compensated Crystal Oscillators) crystal be used as 32768Hz clock input for the CC1310?
Thanks and regards
Luka
Part Number: CC1310 Other Parts Discussed in Thread: CC1312PSIP Hi,
I’m looking for the intermediate frequency (IF) setting for the CC1310. I couldn’t find this information in TI Studio.
Here are the operating parameters:
Frequency: 433 MHz and…
Part Number: LAUNCHXL-CC1310 Other Parts Discussed in Thread: UNIFLASH , CC1310 I have purchased a recent LAUNCHXL-CC1310 Dev Board and I have 0 success trying to force mass erase the chip so we can flash our own code on the hardware. I use the Uniflash…
Part Number: LAUNCHXL-CC1310 Other Parts Discussed in Thread: CC1000 , CC1310 , CC1101 We made a 433MHz FSK wireless loggersystem with an RFPIC as wireless sensor and a CC1000 as receiver. With the old configuration Only the payload is Manchester-encoded…
Part Number: LAUNCHXL-CC1310 Other Parts Discussed in Thread: CC1310 , , CC1311P3 , CC1352P , CC1311R3 Hi Experts,
Can you help with the inquiry below?
A customer encountered an issue with smartrf studio 7. Their cc1310 was configured with frequency…
Part Number: LAUNCHXL-CC1310 Other Parts Discussed in Thread: CC1310 , Tool/software: Hi,
where I can find documentation for version 1.4 of Launchxl-CC1310. I see big difference between version 1.4 and 1.3 because in version 1.4 no chip U7 and I don…
Part Number: CC1310 Tool/software: Hi,
I am going to place my remote based on CC1310 in hard-to-reach place. So I will have access to only one button to control of it.
So, during of testing/field trail I would like to add software option to reset…
Part Number: CC1310 Hello,
I am working on a CC1310 project and would like to use DIO2 and DIO3 as input pins by connecting push-buttons. I understand that DIO2 and DIO3 are used as UART0 RX/TX by default and may have special roles during boot or debugging…
Part Number: CC1310 Other Parts Discussed in Thread: UNIFLASH Tool/software: I have a couple of questions regarding On-Chip OAD support on CC1310:
1)On-Chip OAD Support for CC1310
Does CC1310 officially support On-Chip OAD?
In some TI forum posts…
