Part Number: CC2510 Hello,
I have made a CC2510 module with Johanson Balun 2450BM15B0003. The two of my modules are able to communicate with each other. At 1 meter, RSSI = -42 dBm (With PIFA Antenna) as per TI design guidelines. But the module is not…
Part Number: CC2510-CC2511DK Other Parts Discussed in Thread: CC2511 , CC-DEBUGGER , CC2510 A usb dongle cc2511 does not work
not blink Power led
and also packet sniffer sw does not recognize any my cc2511 dongle
When i connect the dongle to PC…
Part Number: CC2510 Other Parts Discussed in Thread: CC2400 , We are using CC2400 and CC2510 in communication between the vehicle transceiver (tram) and ground (rail switch) transceiver. The vehicle is periodically transmitting radio packets, Ground transceiver…
Part Number: CC2510 Hi,
I use the Vector Signal Analysis of keysight----89600 VSA ,a software can analysis the signal form CC2510.The software can demodulation the different modulation signals and show the data and constellation.When I set the 2FSK…
Hello Venu,
Based on your synopsis it would appear that there is a memory leak or corruption. Which code examples are you basing your project development on? I would recommend making incremental changes to determine which portion causes the issue described…
Venugopal,
Please see the "CC1110, CC2510 Basic Software Examples" available here: https://www.ti.com/lit/zip/swrc117
In cc1110_cc2510_Basic Software_Examples/source/examples/pm you will find powermode2.c which shows how to properly enter power mode…
Part Number: CC2510 Other Parts Discussed in Thread: CC-DEBUGGER , Problem Description:
After preliminary analysis, we have confirmed that the TX port of the module component did not send data to the main control board, but the module worked normally…
Part Number: CC2510 Other Parts Discussed in Thread: SIMPLELINK-2-4GHZ-DESIGN-REVIEWS Hi,
We are using CC2510 as a transmitter for wireless sensors. It has been observed that the board resets. It worked fine for a couple of days after that it starts…
Hello Venu,
If you review the CC2510 Datasheet then you will see that the XOSC and low power RCOSC are running during PM2, however the Timer 1 clock sources are only the HS XOSC/RCOSC so it will be disabled during standby mode. You will therefore need…
