Other Parts Discussed in Thread: SIMPLICITI Hi all!
I have a simple question about SimpliciTI.
I have an installation that make a communication between a ' Holter ' ( worn by a patient) and a 'base' (connected to the Internet via TCP ). The communication…
Hi Everyone,
I am using a Low Cost EEPROM as external memory for OTA, it has I2C protocol only for communication. I have successfully generated the OTA client. As per my knowledge, Bootloader has SPI drivers (initializes USART in SPI mode) ? How can…
Grant,
I tryed to use 9600 but it doesn't work, as you can see down in the picture .
With 38400, it works, but i still have some ugly caracters apearing in the screen.
I believe that the software must write:
Device X Temperature XY C…
Other Parts Discussed in Thread: CC2520 , CC2530EM , Z-STACK , CC2530EMK Hi,
One of our SmartRF05 EB 1.7 was burned while we were doing some experiments, and now we have just one.
But we have 3 SmartRF05 EB 1.3 from our cc2520 kits, and we are trying…
Hi,
You can use Skyworks SKY66112-11 FEM. It has a Bypass mode.
SE2431 (in an App note) can be replaced with SKY66112-11
Attached are the Data sheet and App note. App note is available on our website.
Thanks,
PM
swra439.pdf
SKY66112_11_203225L…
Other Parts Discussed in Thread: CC2530 , TIMAC , Z-STACK Hi TI Employees,
we are developing a huge zigbee 2007/pro network (minimal more than 5k devices) using cc2530, and we have a few questions:
Does the new version of z-stack support beacon networks…
Hello guys,
We are developing a proprietary protocol & we are trying to use 64-bit address to send broadcast packets.
However, the other modules are not able to receive any of the broadcast packets sent. I am not getting the RF interrupt itself…
In this document , it says z-stack and the sampleapp (which is a very simple application) will consume about 6.7k of ram which means we will have 1.3k of ram left. We are going to write our application which will have an uart communication module which…
Other Parts Discussed in Thread: CC2591
Good day for everybody!
I require the help from You experts out there.
I developed a ZNP mini kit that connects via our host mcu.
And then I want to use a CC2591 to the ZNP mini kit
Still, I have…
