Part Number: CC2538DK Hello!
I'd like to connect the CC2538 devices to an STM microcontroller or a Raspberry Pi using a shield. Basically, I'm looking for a shield to replace the SmartRF06 so I can connect the CC2538 to a microcontroller. I've…
Part Number: CC2538DK Hi Team, We have a customer inquiry regarding their plan application for CC2538DK. They would like to perform localization via RSSI with the ZigBee protocol and found CC2538. They would like to obtain the RSSI measurement between two…
Part Number: CC2538DK Hi Team,
I am posting for a customer. They have a CC2538DK and based on their feedback they were not able to detect on Smart RF Studio. They are following this tutorial. http://www.ti.com/lit/ug/swru194b/swru194b.pdf
They are seeking…
Part Number: CC2538DK Hi Team,
My Customer is using the CC2538 development board, and I have a few questions about it.
-What is the receiver's signal strength? I know we can set the transmitter's signal strength, but I don't know what the receiver's signal…
Hello!
To be honest, that doesn't help me. I explained in my previous message that I'm already obtaining the data in a text file (I should have used the term "Data Dump", so maybe that's my bad), and I'm looking for an alternative to this since the SmartRF…
Part Number: CC2538DK Hi Team, I am posting this on behalf of our customer. Our customer would like to know if is there a way to save the continuous RX plot from SmartRF Studio? If saving the plot is not possible, is there a way to simply save the RSSI data…
Part Number: CC2538DK Hello,
I'm trying to install the RIOT system on to the CC2538DK. But I couldn't flash the firmware into the board. According to the RIOT instruction, I need to hold down the SELECT pushbutton while pressing RESET to activate the…
Part Number: CC2538DK Dear,
Contiki codes work well with cc2538 Rev 1 (green board), but for Rev 2 (black board), it is like the transceiver is not enabled and nodes cannot send and receive data.
I did not find any solution for this in any forum.
Please…
Part Number: CC2538DK
I am trying to add the hardware watchdog timer feature for CC2538DK, so I connect the PD5 of CC2538 to WDI of TPS3823-33DBVR , but UART(PA0 & PA1) is not working when the watchdog timer is connected with that pin(PD5). what could…
Part Number: CC2538DK Tool/software: TI C/C++ Compiler Hello everyone.
I am studying the Contiki OS, most specifically, trying to develop an application using such OS. Bearing in mind that I pretended to Debug the Contiki OS in CC2538DK using the CCS …