Part Number: DLP9000XUV I am working on a DMD kit constructed by ViALUX (V-9001 UV), in which the DMD chip is DLP9000XUV. While I created a grey scale pattern for test (4x4, see below) and displayed it (only one frame, illuminate time = 4s, 8-bit, other…
Hi Marcos,
Thank you for the explanation of the resin issue.
Based on your measurements, yes, one bus is having a problem after the boards have been cleaned up. Fizix can review and provide feedback on next steps.
I do want to clarify one of your…
Part Number: DLP9000XUV
Is it possible to design a DMD to operates with two states: off state and parked (flat) state?
From the answer of other similar questions, I've found that this type of operation has long term reliability issue.
But I…
Hello Tim,
Are you able to measure (in pixels) the distance from one line artifact to the next one?
This type of artifact is typically the result of a poorly connected or not connected single LVDS line. Please check the Controller and DMD board pads…
Part Number: DLP991UUV Other Parts Discussed in Thread: DLP9500UV , DLP7000UV , DLP9000XUV My project requires a DMD chip for UV applications. However my wavelength is limited to 310nm, which below the minimum wavelength for DLP991UUV and other UV DMDs…
Part Number: DLPLCR4500EVM Other Parts Discussed in Thread: DLP9000XUV Tool/software: I am looking for DLP lightCrafter product with add-on specifications like DLP 4K resolution and UV-light output.
Part Number: DLPLCR4500EVM Other Parts Discussed in Thread: DLPC910 , DLPC900 , DLP9000XUV Recently, we have the following requirements. We wonder if the DLPLCR4500EVM product can meet them. If it can, please see if specific operation suggestions can…
Part Number: DLP9000X Other Parts Discussed in Thread: DLPC910 , , , DLP9000 , DLPLCRC910EVM Hello,
We are currently developing a board using the DLPC910 together with the DLP9000XBFLS DMD.
Following our previous discussion, we have a few additional…
Part Number: DLPC964 Other Parts Discussed in Thread: DLP991UUV , DLP9000XUV , , DLPC910 Tool/software: Dear Texas Instruments Support Team,
I am currently developing a 3D printing system that utilizes a UV laser in combination with a Texas Instruments…
