Part Number: DP83822EVM Other Parts Discussed in Thread: AM6442 , DP83869 , TLK105 ,
We are seeking information on Ti Sitara AM64x evaluation boards that exhibit hardware compatibility with DP83822 EVM, along with software support.
Alternatively, we are…
Hi Guenter,
Apologies for the late reply, the files can be found here in the following link or attached to this reply.
https://e2 3286.SV601202B_Source.zip e.ti.com/support/interface-group/interface/f/interface-forum/866710/dp83822evm-design-files
Regards…
Part Number: DP83822EVM Hi teams,
My customer has been considering DP83822EVM for his design.
In the schematic of DP83822EVM, my customer would like to replace the resistor of R32, R33, R34 and R35(rated power is 0.125W) to the resistor of the rated power…
Hi Gerome,
thanks for Your reply.
I've an update, I received today the DP83822EVM (from Mouser) - rev 2.0.
Contrary to what was written on the schematic, the PHY soldered on the board has device marking 822HF, which correspond to 83822HF, the one…
Part Number: DP83822EVM
Hi
I am using the DP83822EVM together with a STM32H7-DK and has configured DP83822EVM via bootstrapping. Reading the registers over MDIO works and the PHY is configured as RMII master with a clock output on COL pin (pin 29). I am…
Hello GARETH OU
Thank you for the reply.
I would suggest that we close the thread and open a new thread and reference to this thread a required when customer is done with the testing.
Regards,
Sreenivasa
Part Number: DP83822EVM Hello,
I’d like to ask the about power of DP83822 Ethernet PHY transceiver. VDDIO can be powered by 1.8V or 2.5V or 3.3V. If I understand correctly, it should be the same as the host I/O voltage levels – 1.8V in my case. Can…
Part Number: DP83822EVM Hi Friends.
I am planning to use Chip DP83822 in my project, but I request a RJ45 with internal magnetics and leds.
Could you suggest me a RJ45 with internal magnetics part number to fully compatible with DP83822 10/100 Mbps Ethernet…
Here is my current understanding of your setup, please correct me if there are errors:
Can you send/check packets on the host end? If so, we can iterate through some loopback tests to isolate where the signal chain is failing.
Starting with the custom…