• 

  Dave Melinger

  • 11 months ago
  • Interface
  • Interface forum

  DP83848J: DP83848J thermal Heatsinking Info

  • Resolved

  Part Number: DP83848J Hello e2e Ethernet Forum, we have been using the DP83848J ethernet PHY
• 

  Rob Rodrigues

  • 9 months ago
  • Interface
  • Interface forum

  RE: Compiler/DP83848J: STM32F107RC with DP83848J can't establish ethernet link correctly

  Hi user, What do you mean by in RMII mode you can receive register 0x01? the register set is access by MDIO(SMI) which does not depend on RMII or MII. Are you saying in MII mode you cannot read the registers? If so, that would be a configuration...
• 

  Mark Guastaferro

  • 2 months ago
  • Interface
  • Interface forum

  DP83848I: Data clock outputs at power up

  Part Number: DP83848I New board design uses DP83848I Ethernet PHY. Previous generation used the DP83848J PHY. Corresponding pins are connected and strapped similarly between the two designs, although DP83848I has additional pins. On previous gen design...
• 

  Smith liu

  • over 1 year ago
  • Interface
  • Interface forum

  DP83848J: Are these two the same material ：DP83848JSQ&DP83848NRTAR

  • Resolved

  Part Number: DP83848J Are these two the same material ：DP83848JSQ&DP83848NRTAR
• 

  TS Yang

  • over 1 year ago
  • Interface
  • Interface forum

  DP83848J: simple question about Mac Address

  • Resolved

  Part Number: DP83848J Hi, Is it possible to port the Mac Address to the DP83848? thanks, TS
• 

  yimin bai34

  • over 1 year ago
  • Interface
  • Interface forum

  DP83848J: About LED Behavior issue

  Part Number: DP83848J Hi Sir We used DP83848J for development and below is the schematic we found the behavior of LED_Speed is different. 1. after system power-on without connecting cable, the LED_Speed is on. 2.after finishing system bootup...
• 

  Shlomi Yehezkia

  • 9 months ago
  • Interface
  • Interface forum

  DP83822I: Host have RGMII v2.6 interface only

  TI Thinks Resolved

  Part Number: DP83822I Hi Team, I use today in all old projects DP83848J, I saw that TI have new part DP83822I. I going to use 10/100 speed but my host have RGMII v2.6 interface only, what you recommended to use? Please advise. Thanks, Shlom...
• 

  Patrick Chen

  • over 1 year ago
  • Interface
  • Interface forum

  DP83848J: overshoot/undershoot spec

  • Resolved

  Part Number: DP83848J Hello, Could we provide the overshoot/undershoot spec for signal/clock pins
• 

  Aniruddha Khadye

  • over 1 year ago
  • Interface
  • Interface forum

  RE: DP83848J: DP83848 issue

  Hi Xiao, Since the MII loopback test was successful, I would say that the PHY is working as per system requirement. Higher level problems are more related to the software/firmware used in the MAC and it is out of scope for this forum. I would recommend...
• 

  Patrick Chen

  • over 2 years ago
  • Interface
  • Interface forum

  DP83848J: DP83848J LED Link activity

  • Resolved

  Part Number: DP83848J Hello, LED_LINK is active and show the Link is good. Could I know which Link

Didn't find what you are looking for? Post a new question.

• Ask a new question