Part Number: TMS320F2800157 Other Parts Discussed in Thread: DRV8300 Q1:我根据电机控制 SDK 通用项目和实验室用户指南(文件名spruj26)的增量构建项目,现在电压采样有问题,电压偏移系数正常约为0.5,我的值大于1(如图p1所示),根据用户指南L aunchpadf2800157与drv8323rh连接如图p2所示,且为C9、C10、C11接上了47nF的电容,并根据论坛相关问题进行如下操作:
对于 S2 、将 SEL1…
Part Number: BOOSTXL-DRV8323RS Other Parts Discussed in Thread: MSP-EXP430F5529LP , DRV8323 , MCT8316Z Hello,
I'm looking for a way to use the BOOSTXL-DRV8323RS at a constant speed with varying loads. The BOOSXL_DRB823X GUI used with the MSP-EXP430F5529LP…
Hi Jungwon,
JUNGWON KIM said: 1. DVDD의 정식 이름은 무엇입니까?
D VDD is the D igital Voltage supply
JUNGWON KIM said: 2. VDD 앞의 D는 무엇을 의미하나요?
V DD is the V oltage supply
Best,
Sarah
Part Number: BOOSTXL-DRV8323RS Hi Team,
The customer wants to know whether it is feasible to add inductors to the three phases of the brushless DC motor to reduce the slope and amplitude of the drive current, thereby reducing the temperature rise of the…
Part Number: BOOSTXL-DRV8323RH Hi,
Can you please help to confirm if little resistor e.g. 10 ohm is needed in GH and GL line to prevent oscillation damage MOSFET ?
also for the resistor C1, is it connect to board GROUND or to MOSFET's SOURCE ? such as…
Part Number: DRV8323R I am using drv8323rs partnumber. Due to a design mistake, I did not include the DVDD's decoupling capacitor in the artwork. At this time, when operating the motor, an unknown offset was detected in the motor current depending on…
Part Number: BOOSTXL-DRV8323RS While spinning a BDLC motor in 1x PWM mode, I keep getting a "VOLTAGE" fault in the GUI window (where the speed and direction is set), which causes the motor to stop. To be clear, this is NOT an Overvoltage, Undervoltage…
Part Number: LAUNCHXL-F280039C Hi team,
I can't select "DRV8323RS" in UMCL syscfg. Also I can't choose "2" at Number of Motors. Is something wrong?
・Board :LAUNCHXL-F280039C
・Motor Driver :DRV8323RS-EVM
・control method :FOC…
Part Number: DRV8323R Other Parts Discussed in Thread: DRV8353 Hi support team.
My customer is considering BLDC motor system with sinusoidal control by using hall sensor.
They asked us about sinusoidal drive with DRV8323R on 1xPWM mode.
Is it possible…