Hi Divya,
Thanks very much for the info, and for debugging further w/ waveforms provided
Regarding hall feedback error:
We suggest adding hall sensor output filtering to try and help with the observed glitching
in CSA filtering, we often times…
Part Number: DRV8350 After troubleshooting the Eval board for way too long,
I have taken a DRV8350H-EVM and disconnected the included Microcontroller's control signals from the DRV8350 since I was getting MCU faults with no explanation
This is to…
Like the DRV8350H-EVM,It's RMS current is 15A,It's peak current is 20A only,so how can i improve the peak current ?It's decided teams are thermal management and overcurrent of software?
Thank you for answering my question.
but I still have a question .
In the DRV8350H-EVM, the peak output current is 20A，but I need a almost 30A peak current output ,
do Ti have the similar design?
Lining,
All code available for DRV8350 is located on the EVM tool folder page here:
http://www.ti.com/tool/DRV8350H-EVM
DRV8308 files are in this thread:
https://e2e.ti.com/support/motor-drivers/f/38/p/787557/2912142?tisearch=e2e-sitesearch&keymatch…
Ramon,
Thanks for bringing this to our attention. The files have been fixed and you will see them here within a day or two:
www.ti.com/.../DRV8350H-EVM
Regards,
-Adam
Hello Eddie,
Just now ,I tried a new board and followed the instruction to have finished programming MSP430F5528 , Now it installed the all COM Port, just like below.
So I can use the GUI of Drv8350x EVM. But as I enabled the DRV8350H device, the…
