Part Number: FDC1004 Hi,
We are testing Evaluation board FDC1004EVM to measure small capacitances.
We have an important constraint about the good stability of capacitive offset in the time and with temperature.
Our goal is to measure small capacitance…
Part Number: FDC1004 Hi Team,
My customer want to do capacitance touch sensor in their smart lawn mower, 3 channel input is enough, could you please kindly help to check if FDC1004 is the most suitable device to recommend?
And for FDC1004, if this device…
Part Number: FDC1004 Other Parts Discussed in Thread: TIDA-00828 I want to emulate a common mechanical rotary encoder with a capacitive sensor. Not sure if this is the right EE Forum or part number.
Goal is to create a circular pattern on a front panel…
Part Number: FDC1004
Need some clarification in the below queries.
We used a spherical container for liquid level detection using FDC1004 board. We are getting a graph like below. while water level is decreasing suddenly capacitance is increasing…
Part Number: FDC1004 Hi team, I'd like to use the daisy chain I2C with multiple FDC1004s connected. Can FDC1004 be daisy-chained? If ok, how do I set the address? BR, Kengo.
Part Number: FDC1004 Has anyone seen an effect on the sensor response in close proximity (2M) to a CFL lamp?
Since the part operates at 25KHz, and CFL lights now operate in this range, what can be done to remove the interference?
Other Parts Discussed in Thread: FDC1004 Good morning, my name is Lucía, and I am writing from the Faculty of Engineering in Oro Verde, Entre Ríos, Argentina. Some time ago, as part of a project, we purchased the FDC1004 kit and we want to use it to measure…
Part Number: FDC1004 Hello,
I am planning to utilize the FDC 1004 for measuring the deviation in a comb drive. For this purpose, I will be employing a voltage source. My capacitance measurement involves the CIN and the GND potential of the voltage source…
Part Number: FDC1004 Hi, I had a couple of questions. I was wondering if someone could check and verify my design/ layout? Want to make sure the SHLD connections as well as the traces in parallel with the CIN traces make sense. Also, my next question…