Part Number: INA194 Hi Team,
I will need your support to do a schematic review for failure analysis on PN INA194AIDBVR.
L1 - 6.5 – 9 uH, DC Resistance 3.5mOhm
R36 - 5.6 Kohm, 0.1 W
C36 - 1 nF, 50 V
TH1 - 220 Kohm, 210 mW
C22 - 470 nF, 16 VD…
Part Number: INA194 Hi Team,
my customer has started a new design with INA194AIDBVTG4, could you please confirm that the device will no be intended to obsolesce for the 5 years ahead?
Thanks and regards,
Shai
Part Number: INA194 hi team,
could you please confirm the INA194 max input voltage on Vin pin?
datasheet claims as below:
I'm confused with the Analog inputs range: -18~18V. if the chip can deal with 80V common mode, the analog voltage on Vin should…
Part Number: INA194 I am trying to provide a valid P/N for the INA194 current shunt monitor. When I check a distributor's stock I get many variations on this theme:
INA194AIDBVR
INA194AIDBVRG4
INA194AIDBVT
INA194AIDBVTG4
INA194AQDBVRQ1
Most manufacturers…
Part Number: INA194 Other Parts Discussed in Thread: INA282 , INA213 Hi Team,
I have a customer who is using the INA194 and had a question about the operation of the INA194 in the Low VSense mode as specified on page 19 of the datasheet.
In the case when…
Other Parts Discussed in Thread: INA194 , LMP8640HV I have a prototype board that uses an INA194 (SOT-23-5) to measure current from a high side shunt.
Shunt - 0.012 ohms
Current range - 0 - 5 Amps (0 - 60mV)
Common mode voltage - 200mV to 48v (typical…
Other Parts Discussed in Thread: INA194 Hello,
My customer uses the INA194, monitoring a current of 24V supply line.
V+ is 5V, a external comparator trip level is 0.7V.
Power up sequence is as follows.
1. V+ = 5V ON
2. 24V supply line ON
According to the…
Part Number: INA194A-Q1 Other Parts Discussed in Thread: INA293 , INA194 , INA290 , INA281 , INA280 Please let me know if there is accuracy better than the INA194AQDBVRQ1. Also, if there is an isolated current amplifier that is inexpensive and has good accuracy…
Other Parts Discussed in Thread: INA194 Hi Team,
INA194 seems to be a high side current shunt device. However, can you use it as a low side current shunt monitor ?
I can find the description on the product page, but, no description in the datasheet.
If…
Other Parts Discussed in Thread: INA194 , INA210 , INA213 I have five high side inductive current monitor circuits each driving hydraulic solenoids. The INA194 is used to measure the current and the inductive flyback. The specs are: 0.62 ohms sense resistor…