Part Number: INA226 Tool/software: Dears,
Recently, the current monitoring of INA226 in the customer's radar equipment failed. The current value read was fixed at 8192mA, and the actual value should be within 20mA. After replacing the new INA226, the…
Part Number: INA226 Other Parts Discussed in Thread: INA230 , CS-AMPLIFIER-ERROR-TOOL Tool/software: Hi team,
Could you kindly help provide a detailed comparison between the INA226 and INA230 based on the worst-case scenario, considering offset and gain…
Part Number: INA226 Tool/software: Hello,
I noticed that input bias current of INA226 has recently been updated on the datasheet revision B.
- Decreased input bias current typical value - Updated Shunt Input Gain Error vs Common-Mode Voltage graph and…
Part Number: INA226-Q1 Other Parts Discussed in Thread: INA226 Tool/software: Hello team,
Is there any situation will cause abnormal I2C communication between the host and INA226: no response to the host (either ACK or NAK) for a long time, and the I2C…
Part Number: INA226 Tool/software: Hello
I want to monitor current of the load,
INA226 can be measured the below current spec. ?
Required Spec.
1. Current sesnsing Range : 200 uA ~ 500mA
2. DC Power : 12 V
Thanks.
Part Number: INA226-Q1 Tool/software: Hi, Support Team
we saw INA226-Q1 operating temp is -40 to 125 deg , if over spec TA is -50 deg , the ic fail rate and failure mode?
if any suggestion, Please advise me.
Thnaks,
Best regards,
Lawrence
Part Number: INA226 Other Parts Discussed in Thread: INA149 Tool/software: Hi Everyone,
I need to measure DC current bidirectional max ± 10A and searching best solution about it.My accuracy need to ± 5 ma.
Now i don t need to voltage measurement…
Part Number: INA226 Tool/software: Hey Amplifiers Team,
I have a customer working with the INA226 on a project and we noticed that the latest revision (Rev B) of this device's datasheet is completely missing the register descriptions which should be…
Part Number: INA226 Other Parts Discussed in Thread: INA230 Tool/software:
Hello,
We are using the INA226 for voltage measurement in one of the projects and have some questions regarding the configuration of the IN+ and IN- pins for accurate bus…
Part Number: INA226 Other Parts Discussed in Thread: TIDA-00313 Tool/software: I have a design using two INA226 to measure +12V and -12V and a common ground. For negative bus, I have left the VBUS connection open, and I am trying to measure the shunt…
