Part Number: LAUNCHXL-CC1312R1 Other Parts Discussed in Thread: CC1312R Thank you for answering
[question 1] We found that the optimal load impedance for the circuit below is: optimun Load Impedance (40 + j15 Ω) @ 868MHz on swra640g.pdf page 29
So…
Part Number: LAUNCHXL-CC1312R1 I am designing a balun using CC1312R1.
I am using swra640g.pdf to get design information.
[Question 1] Where is optimun Load Impedance (40 + j15 Ω) on swra640g.pdf page 29 mean? Is it behind unburanced?
[Question…
Part Number: LAUNCHXL-CC1312R1 Hi team,
Is it possible to receive the packets encoded by Manchester Encoding like the figure below? In customer's use case, competitor's sub1GHz module sends Manchester Encoded packets, and CC1312 receives it.
…
Part Number: LAUNCHXL-CC1312R1 Other Parts Discussed in Thread: SYSBIOS Can i know the example code of combine of Queue and Task (<ti/sysbios/knl/Queue.h> and <ti/sysbios/knl/Task.h>)?
The condition is: two or more task, each task will communicate…
Part Number: LAUNCHXL-CC1312R1 Other Parts Discussed in Thread: CC1312R Hi TI team,
I was looking for a tool to read contents of external flash on CC1312R1 and R7 (flash - Macronix MX25R).
The only tool I could find was "flash-rover" ( https:…
Part Number: LAUNCHXL-CC1312R1 Other Parts Discussed in Thread: SYSCONFIG Hi team,
May I ask you questions regarding manchester coded binary modulation?
1. My customer would like to set the protocol to manchester coded binary modulation(FSK/GFSK). May…
Part Number: LAUNCHXL-CC1312R1 Hi team,
My customer would like to configure the RF frequency to 1200MHz, but it seems like CCS doesn't allow to do it from the figure below. Are there any ways to configure RF frequency to 1200MHz?
Best regards,
Shunsuke…
Part Number: LAUNCHXL-CC1312R1 Hey,
I use CC1312R1 and I've noticed that sometimes when i turn off the voltage supply, the FLASH erase itself.
I had some research and it occurs because the CS (Chip select) is trying to write while VCC is going down…
Part Number: LAUNCHXL-CC1312R1 Other Parts Discussed in Thread: UNIFLASH , , CC1310 , WMBUS , CC1350 Hi!
I'm trying to flash a launchxl-cc1312r1 with "Serial_CC13xx_Collector_T2.hex", so I can communicate with the device via the SATP API Interface. I have…
Part Number: LAUNCHXL-CC1312R1 Hi TI team, I have a general question about NVS implementation to read / write to external flash (Macronix MX25R)
What is the rule of thumb using NVS_open() and NVS_close().
For each read transaction should I call NVS_open…