Part Number: LDC1000EVM Other Parts Discussed in Thread: LDC1101 Hi!
I used the LDC1000EVM to test if this sensor can works for my application. I did some test with all the evaluation board and the measures were fine. Then I broke the MCU board and connect…
Part Number: LDC1000EVM Other Parts Discussed in Thread: LDC1612 , LDC1614
How I can modify an LDC to measure the displacement of the glenoid component loosening from the bone substitute (basically measure the edge displacement as seen in figure)…
Part Number: LDC1000EVM Other Parts Discussed in Thread: LDC1101 , LDC1614 I had earlier installed gui 1.0.4.1 version which was not supporting the change of Rp value for finding out the optimal Rpmin and Rpmax values like in the empirical procedure. I…
Hi Luke,
so the easiest way to solve this is to install an old firmware version for the ldc1000evm (see: https://e2e.ti.com/support/sensor/inductive-sensing/f/938/t/324500 ) . Once you installed the old firmware you are able to use the USB CDC protocol provided…
Part Number: LDC1000EVM
Hi Team,
The customer is using LDC1000EVM. He watches the video that you can change the LDC1000EVM default sensor coil tp a coil of your choice.
In the video, the engineer uses a Impedance analyzer to measure the Rp_MAX,Rp_MIN and…
Part Number: LDC1000EVM Other Parts Discussed in Thread: LDC1101 Hello experts,
I use the LDC1000EVM and I want to increase the Output Data Rate of the LDC1000.
So i set the Response Time to the lowest level, but the EVM Output Rate did not change.
Wich…
Part Number: LDC1000EVM Other Parts Discussed in Thread: LDC1101 Hello!
I made a sensor, about 220 turns with a 0.2 mm wire, a winding diameter of about 1.5 cm. I chose the frequency below to see the difference between ferrous metals and non-ferrous metals…
Part Number: LDC1000EVM Other Parts Discussed in Thread: LDC1101EVM , LDC1101 I am testing a combination of LDC1000EVM and Proximity Sensor (OMRON E2C-X10A) But there is a problem. Inductance measurement value of LCR meter(sanwa LCR700) and LDC1000 does…