Hello Brian,
You have successfully put the MSP into BSL mode. The next step is to reflash the EVM. With this EVM you actually have to use an additional software to reprogram the MSP portion. There are further instructions and a link to the MSP430 Firmware…
Part Number: LDC2114 Hi,
I measure waveform of INx on LDC2114EVM, but the signal doesn't drop to 0v after sampling. no matter NP mode or LP mode. It is different from the waveform in design guide. Inductive Touch - Configuring LDC2114 Touch-Button Sensitivity…
Hi Ben,
thanks for your helpful answer.
One thing that might not be clear: When using the LDCCOILEVM with the LDC2114EVM
there are two possibilities to place the sensor capacitor. First one on the LDC2114EVM and second one on
the LDCCOILEVM. Do…
Hi Varn,
thanks for your answer.
A guide through changing that bit via PuTTy would be great
Will the source code the MSP430 is using on the LDC2114EVM be released soon?
Regards,
Clemens
Hello Chetan,
I am sorry to hear you are still encountering issues with the EVM.
I appreciate the pictures and further description of the error you are encountering.
There is one more procedure we can attempt in order to resolve the issue. The MSP…
Part Number: LDC2114 Hi
We are using LDC2114EVM for evaluation.
I noticed this device recognizes initial sensor environment because it always seems to generate DATA = 0 when start up wherever it is.
Is my understanding correct?
If possible…
Part Number: LDC2114 I have a 10mmx8mm coil, with a free air inductance of about 2.6uH and a resistance of ~2ohms. If I connect to the LDC2114EVM board, with its 47p capacitor, I can get reasonable results detecting an aluminium can. The coils oscillates…
Hi Clemens,
The LDC2114EVM uses the MSP430 to communicate to the LDC2114 device via I2C. Your understanding is correct, you should not see any issues using the USCI I2C block to communicate with the LDC2114.
Regards,
Varn.
Part Number: LDC2114 Other Parts Discussed in Thread: LDCCOILEVM Hi,
after building some ToM-prototypes with the LDC2114EVM and LDCCOILEVM
i realized it works quite well.
But especially when i adjust the gain to high values, there occur some fals…
Hi, Varn Khanna,
I'm doing test on the LDC2114EVM．
when the conductive target is on the sensor, it will act as normal: that channel is active.
but if I keep the target on the sensor for a few seconds, the board will turn that sensors' status to…
