Hello,
Since we have not heard back in a while, I am going to close this thread for now. If you have more questions, you can re-open this thread by replying or open a new thread.
Best regards,
Ridge
Part Number: LM5017
Hi,
I designed LM5017 buck to step-down 60V to 3.3V which has 3 three wires
1- Power ( Input from 60V Battery )
2- GND ( Commond ground )
3. 3.3V ( Output to MCU )
Above 3 wires goes through a single connector. Above system is working…
Part Number: LM5017 Other Parts Discussed in Thread: LM5169 Hello ,
TI indicates that LM5017 is 100% compatible with LM5169.
But it is not true because pin 4 in LM5017 indicated to link a resisitor to VCC while pin 4 in LM5169 indicated to link a resisitor…
Part Number: LM5017 Other Parts Discussed in Thread: LM5169 Hello Sir:
Please refer our schematic as below.
VIN is around 25V to 67.2V.
Can we just replace it with no change other components?
Please kindly provide your recommendations for us.
Looking…
Part Number: LM5017 Dear TI experts,
The circuit below is from the spec of LM5017,
My question is why the inductor in series with a resistor R8?
When should I put R8 in the design?
thanks!!
Part Number: LM5017 Other Parts Discussed in Thread: LM5161 , LM34927 , , LM5180 The customer wants to find a 24V to 12V isolated power supply chip. The application is the gateway module in the DCS system. The performance requirements are as follows:
The…
Part Number: LM5017 Other Parts Discussed in Thread: LM5160 Hello I'm currently designing a fly-buck based on a LM5017.
My main question is about the low side switch. Do we have to take care of a low side current limit (like in the LM5160) ? Should…
Part Number: LM5017 Hi Team,
In datasheet it says " There is no diode emulation feature in this IC, and therefore, the inductor current may ramp in the negative direction at light load. This causes the converter to operate in continuous conduction…