Part Number: LM5051 Hi Expert,
My customer want to see if TI have any similar solution to replace the IR5001S.
They want to find the one part can put to used in both of high side and low side.
Please share your comment for me .Thanks!
Eddie
Part Number: LM5051 Hi Support team
According to the datasheet, when MOSFET is ON, INN PIN will be -100mV, nFGD will be high When MOSFET is OFF, INN PIN will be -600mV, nFGD will be LOW But the signal I measured at CH1 is -700mV, CH2 is also high…
Part Number: LM5051 Other Parts Discussed in Thread: TPS40075 , LM27403 ,
Hi Team,
Our customer is looking for a DC/DC converter with Vin = 15V and Vout = - 12V, Iout = 2A and can be connected in parallel to the same DC/DC converter to increase the…
Part Number: LM5051 Other Parts Discussed in Thread: LM5050-1 , LM5050-2 , UCC29002 Hello,
Instead of using a Schottky Diode, i want to use the LM5051 with a Mosfet to make a ORing and have a small voltage forward.
I'm using two EPP-500-54, which…
Hello Park,
Surge energy needs to be absorbed by MOVs at the input.
We recommend to select the MOVs based on 4KV surge pulse rating. At 4kV, 2ohm surge impedance, 2000A current could flow. Need to choose an MOV that clamps with 2000A with clamping…
Part Number: LM5051 Hi Support team
1. PIN1, I used 10kohm for external resistor . Is there any suggestion value for this resistor ? Because there is already 50kohm inside, can we still need to add this 10kohm?
2. May i have IVCC curve in different…
Part Number: LM5051 Hi Support team
The schematic is as follows, Pin1 input is 40~72VDC, there is a 10kohm resistor
I am going to measure Pin2 VCC, it's only about 8.2V. Why is it not 13V that Vz clamps? According to the internal circuit, there…
