Hi, John and Jimmy
Thanks for your explanation.
LMZ35003 application spce: Vin = 10V~30V, Vout = 8V, Iout = 1A average, 1.5A max.
Customer has tested their system in 30C ambient temperature. The top case temperature of LMZ35003 is 60C. So the temperature…
Other Parts Discussed in Thread: LMZ35003 , LMZ36002 I'm working on an application that would take 48V in and generate 5V at the output. The input supply is +/- 5% meaning it could stray to 50.4V, slightly higher than the recommended operating conditions…
Part Number: LMZ34002 Other Parts Discussed in Thread: LMZ35003 , Hi, I noticed there is an app note for paralleling LMZ35003 Power Modules. As the LMZ34002 is basically a negative version of the LMZ35003, I was wondering if it is possible to parallel…
Other Parts Discussed in Thread: LMZ35003 Hi,
Please let me ask about output capacitor selection for LMZ35003.
You recommend the minimum output capacitor at least 100uF, then can we use 100uF typical value capacitor like below? I'd like to know…
Other Parts Discussed in Thread: LMZ35003 , LMZ34002 The data sheet advises to not connect the PH pins to any other net. My customer interpreted that to mean that they should not be connected together either. I believe that all of the PH pins are connected…
Other Parts Discussed in Thread: LMZ35003 , LMZ31710 Hi,
Please let me ask about maximum soft start time. I believe that there is no limitation for maximum soft start time, but I'd like to ask if you have any concern at too slow start-up setting. Actually…
hi
there are two GNDs: AGND and PWRGND as per recommendations both have to be connected to each other through pins no 8, 9 GND_PT. out of these two GNDs which has to be connected to main PCB GND
1) out of these two GNDs which has to be connected to…
Other Parts Discussed in Thread: LMZ35003 Hello:
I have a few question on the LMZ35003 Power module. I am considering using this to replace a 78SR105SC Power Trends Switching Regulator
Module. The input voltage would be 7 to 48 VDC, Output to be 5VDC…
Other Parts Discussed in Thread: LMZ35003 Hi folks,
Is the LMZ35003 is capable of coating? Most of the ICs allow to coated,But I am wodering because the LMZ35003 is MCM.
Is there any restriction other than heat issue?
Other Parts Discussed in Thread: LMZ35003 Hi,
LMZ35003 does not have ISHARE pin but Unencrypted PSpice Average Model has ISHARE pin actually. So...
Can you revise this model and remove ISHARE pin?
Please let me know how connect ISHARE pin or float…
