Part Number: MCT8316Z Other Parts Discussed in Thread: MCF8316D There have been previous questions in the forums regarding the brake function on the MCT8315/6 controllers and the fact that, while the brake is effective at stopping a rotating motor, at…
Part Number: MCT8316Z Hi, I'm using the MCT8316Z (spi version) BLDC motor controller, to control a brushless motor with digital hall effect sensors. My schematics (I believe) follows the EVM and reference designs, and is nothing out of the ordinary. I…
Part Number: MCT8316Z Other Parts Discussed in Thread: MCF8316D Tool/software: MCT8316Z SPI version does have internal phase current Isense feedback however these signals are not provided outside instead used internally comparing them to external limit…
Part Number: MCT8316Z I have a custom board with a microcontroller controlling two MCT8316Z0TRGFR.
Not on all but some of our boards (5 out of 20), the MCT8316Z0TRGFR does not switch direction although we checked that the dir input toggles.
Forum…
Part Number: MCT8316Z Hi Team,
Posting on behalf of our customer.
I am working with the SPI version of MCT8316Z motor driver. Due to a specific application and motor specification i have to drive the motor below 4.2% duty cycle and Vavg for my case…
Part Number: MCT8316Z We're using the MCT8316Z. We poll STATUS_1 over SPI every 50 ms to monitor the over-temperature warning (OTW, bit 7) so we can shed motor load before thermal shutdown.
Issue: Across many thermal tests we have never observed OTW…
Part Number: MCT8316Z Tool/software: I created a circuit for driving a motor using the MCT8316Z0R (SPI). So far, it is working as intended.
To detect fault conditions, I would like to detect motor open circuit and hall sensor open circuit. I thought…
Part Number: MCT8316Z
Tool/software:
Hello Dear All,
I have 3 boards with MCT8316Z and I am sure everything is same with EVM Board. My VM is 6V and nSleep pin is high with 3.3V.
In two boards, I have nothing on SW_BK output and my Vch is 5.6V…
Part Number: MCT8316Z Tool/software: Hi Team,
we are going to use the Align sate configuration, I have a question about this configuration about driver output setting.
1. Why is it necessary to simultaneously energize the A-B and A-C motor phases…
Part Number: MCT8316Z Tool/software: I want to use the built-in DC/DC converter and LDO regulator for "bootstrapping" my MCU (a Renesas RA0E1).
However, when applying VM (12V, in my case), the DC/DC won't start up.
Is there any pin (apart from the…
