Part Number: MCT8316Z
Dear all,
we are again facing a trouble with the "HW" version of the MCT8316Z driver. Please consider the schema below.
The situation is following: the driver is controlled by discrete 7400-based logic. The driver is set to…
Part Number: MCT8316Z Dear all,
on our endevours to develop an electromechanical actuator we had hit another problem with HW-controlled MCT8316Z motor driver. Our situation looks as follows:
In the application we control the driver using 7400-based…
Part Number: MCT8316Z
Dear all,
on our endevours to develop an electromechanical actuator we had hit yet another problem with 'HW-controlled' MCT8316Z motor driver. Our situation looks as follows:
In the application we control the driver using…
Part Number: MCT8316Z Tool/software: I have an MCT8316Z. Everything seems to be working. I can read and write registers no problem. But after a reset, some of the register values do not match what the datasheet states. For instance, Control_Register_2A…
Part Number: MCT8316ZMCT8316ZT has a 16A over current protection.
I want to understand that how it works as the ILIM limit is 8A. So how the current will reach 16A when we turn off at 8A in each cycle?
Part Number: MCT8316Z I have a 24V low inductance BLDC motor (with Hall sensors) with a phase-to-phase inductance of 11,4 uH which Mode setting shall I use to control such a motor with MCT8316ZT.
Do I need external inductors to drive such a motor with…
Part Number: MCT8316Z
Tool/software:
Hey everyone,
In our design we use the HW version of this driver to run the Faulhaber 2250S024BX4 with three (analog) Hall sensors. Having studied the datasheet and the MCT8316ZTEVM Evaluation Module documents…
Part Number: MCT8316Z-Q1 Tool/software: Hello Dear All,
I want to set up my ILIM limit to 3A, for this value how can I calculate my ILIM resistors? Is there any formula or resistor value?
I checked evm manual and datasheet but I did not see.
Best…
Part Number: MCT8316Z Dear Experts,
is it now possible to set the CSA gain in the SPI Variant of this IC? The most recent Datasheet is from 2021, the answer in the forum "There is a mistake in the datasheet" is from 2023. Did it get fixed in the meantime…
Part Number: MCT8316Z Tool/software: Hello,
Please look at video which I atteched.
After supply 21-22V my brake pin is not working. Same with EVM board and my custom design. I tried with 2 different motors.
Under 21V suppling everythin is awesome…
