Part Number: MSP430F5437A
I'm going to investigate the issue with power-up on the revision F of MSP430F5437A. We have used revision H of MSP430F5437A for more than 10 years and are going to switch it to the revision F of MSP430F5437A because of material…
Part Number: MSP430F5437A Other Parts Discussed in Thread: MSP-FET Hi,
I need to run debug on an old product. I have the tools and connectors used at the time development was done on it but cannot get the JTAG communication running. I'm using a MSP-FET430UIF…
Part Number: MSP430F5437A Other Parts Discussed in Thread: MSP430F5437 , MSP430FR6043 , Hi,
Is there a register I can read to know the Die revision number of the microcontroller?
Regards
Lakshmi
Part Number: MSP430F5437A Other Parts Discussed in Thread: MSP430F5437 , Hi,
I have this TI microcontroller with part number "MSP4305437A Rev F" on it.
But when I connect it to the flashpro via JTAG and do an AUTO PROG., I see the following error…
Part Number: MSP430F5437A In our design we are using MSP430F5437A,
Please confirm the JTAG interface signal connection for the MCU boo loading/debugging.
No Pull up resistor added in TCK,TMS,TDI,TDO signal is it Ok to proceed.
Please suggest.
Part Number: MSP430F5437A With reference to the thread- https://e2e.ti.com/support/microcontrollers/msp-low-power-microcontrollers-group/msp430/f/msp-low-power-microcontroller-forum/138532/clarification-on-sys12-issue-in-msp430f541xa-543xa-errata
The VPE…
Part Number: MSP430F5437A Other Parts Discussed in Thread: MSP430F5418A Since the MSP430F5418A is currently not available, we want to run our source code on the MSP430F5437A.
Our product is now more than 10 years on the market and therefore we use an…
Part Number: MSP430F5437A Other Parts Discussed in Thread: MSP-FET Hi,
I am using MSP430F5437A controller for application , i am facing some unknown issue while programming( flashing code into controller )
in my application i am using tool MSP-FET Flash…
Part Number: MSP430F5437A Debugging some issues on an existing product.
General Question: MCLK is set to 4MHz, but the firmware changes it to 8MHz every 16ms, while performing some ADC calculations, and then switches back to 4MHz. (Assuming it was implemented…
Part Number: MSP430F5437A The minimum RST pulse width requirement for the MSP430 is 2us. What would be the consequences if this pin saw a pulse width less than 2us (say around 1us). Would the MSP completely ignore any pulse that's less than 2us, or would…