Hi Ben
This is normal there is a small spike noise for each sample. So, we increase sample time by ADC10SHTx.ADC10CTL0 setting. The spike noise for each sample still can be seen. The ADC conversion code should be correct because this spike noise has been…
Part Number: MSP430F5510
Dear All,
I have designed a PCB that has a XT1 external 32.768KHz crystal attached across XIN & XOUT.
I am trying to configure the RTC_A and to toggle P1.1 and P1.2 output every minute in software.
But RTC doesn't work. What…
Part Number: MSP430F5510 The data sheet does not have levels for the voltage that we are running the MSP430 at, 2.5V
What is the Vih for VCC = 2.5V?
May we use Figure 5-18 to estimate the Vih, Vil and hysteresis levels?
James and Hari,
If this MSP-GANG was purchased through a distributor, please contact the distributor they purchased from for a return.
If the MSP-GANG was purchased from TI, please contact the TI customer support center: https://ticsc.service-now.com/c…
Part Number: MSP430F5510
Hi
My customer developing MSP430F5510 and F5529.
I want to check about operation of MCLK that when reset and when all registor value not change reset.
Q1: when reset, MCLK souce is DCOCLKDIV that divide (N+1) FLLREFCLK.
In TRM…
Part Number: MSP430F5510 Other Parts Discussed in Thread: MSPWARE 1.In MSPWare ,i donot find this application" MSP430_USB_Firmware_Upgrade_Example" for firmware updation in MSP430F5510IRGC.
Please Provide the path of setup.
Hello,
I am trying to work with a custom board design (done by someone else) which has a MSP430F5510IRG with a USB connection. I was wondering if it is possible to invoking the BSL by using any of the PINs listed below? (The board has no connections to…
Other Parts Discussed in Thread: CCSTUDIO , MSP-FET Hello,
I am starting to work with the evaluation Kit (MSP-TS430RGC64USB), which has a MSP430F5510IRGC inside. To get started with this kit, I was trying to debug some simple code (i.e., Blink the LED on…
Part Number: MSP430F5510 I have a LED I am trying to flash at about a 5Hz frequency. The LED when "high" is run by a PWM output. When the flashing timer interrupt stops PWM from occurring, sometimes it leaves the LED pin on high. This creates three modes…
Part Number: MSP430F5510
I need to know the requirements for selecting an external clock source (CMOS oscillator) for XT2 for USB. This design is considering a 4MHz clock source (this would also allow USB BSL due to auto-detect to set XT2 to bypass mode…