I currently am using the i2c module set up as an interrupt.
Is there available code that would show me how to set up the I2c for polling instead of interrupt driven? If so could you send this code to me.
Steve
I have 4 pins set up to capture pulses. Port2 bit 6, Port2 bit 7, Port3 bit 0, and Port 3 bit 1. I am having trouble getting these pins to capture. Can you help by sending me a setup for Timer1 and Timer2 based on what the spec sheet is saying as shown…
Other Parts Discussed in Thread: MSP430F6721 The ACLK is being sourced from REFOCLK and under normal operating conditions, everything is working just fine. The MCLK / SMCLK are running at 8MHz and the 24bit AtoD is working well at 2MHz. The LCD is producing…
The main thing that changes between MSP families is the clock system. But the basic concept has remained the same for almost everything.
Of course new features require new code, but in most cases, existing low-level code for peripherals can be re-used…
Other Parts Discussed in Thread: MSP430F6721 I have seen in the forums that almost everybody uses an external IC like ADS124X or LMP90XXX to interface to the RTDs (using a constant current source passing through the RTD). I would like to use the SD24_B…
Other Parts Discussed in Thread: MSP430F6721 Hi,
I'm using a MSP430F6721 during my reseach. Could anyone show me how to enter Low Power Mode 3.5 or 4.5?And how could I know whether if it enters? I have read the user guide for many times but still cannot…
Other Parts Discussed in Thread: MSP430F6721 , MSP430FR5729 i develop board for testing using msp430f6721. but i am not able to run crystal. i am using ccsv5 and dump one of refrence code provided by ti. but it still not working. i dump following code
…
Other Parts Discussed in Thread: MSP430F6721 Hi,
On MSP430F6721, I connect DVCC to one battery (2.7v), and connect AUXVCC1 to another battery(3v), I found ater switchover, AUXVCC1 is working power supply, it still ouput current from DVCC pin, which will…
hey i m facing the problem in writing in the registers of RTC_C. in single step debug it will not modify anything it will give 0000 for any value.
and my program is not going in ISR also... So is there can anyone help me in this...
I cant find my fault…