Part Number: MSP430FR6043 Other Parts Discussed in Thread: MSP-FET We have been using a dev board for several months with no issues.
We are switching to custom boards. Using CC and MSP-FET with spy-by-wire setup.
At times, the debugger works great, we…
Part Number: MSP430FR6043 Hello Community,
I need clarification on the following points:.
1. I want to add the low power mode to our system for the MSP430FR6043 water measurement. According to Table 9-1. Operating Modes, the USS_A module is operational…
Part Number: MSP430FR6043 We have a variable we don't want to be initialized when we program the boards.
We used the #pgrama NOINIT(VarName) in the code and the link command file we have main.obj(.TI.noinit:VarName).
If we program the board and manually…
Part Number: MSP430FR6043 I'm trying to output a PWM signal corresponding to ToF. Testing it with 50% duty cycle right now to verify I can get the signal on the pin I expect.
Within system_pre_int.c I added the code below.
/* Insert your low-level…
Part Number: MSP430FR6043 Other Parts Discussed in Thread: MSP-FET We are trying to bring some custom boards online and switching from the embedded EV-FET on a demo board to using the MSP-FET programmer. We are getting this error.
MSP430: Error initializing…
Part Number: MSP430FR6043 C:\ti\ccs1250\ccs\ccs_base\msp430\include_gcc\msp430fr6043.ld, line 48, has LENGTH = 0x5EC7 , which actually should be LENGTH = 0x0EC7 .
This is only for GCC compiler, while for TI compiler the size is correct:
And seems other MCUs…
Part Number: MSP430FR6043 Other Parts Discussed in Thread: EVM430-FR6043 Hello, i have a problem with the Board EVM430-FR6043. and namly i tested the Board with 1MHz sensor and it worked well. then i used 2Mhz sensor, and the signal was different by different…
Hi Eason,
Thanks for your reply! It is a problem with my board. I had ordered a new board and its working now. My co-worker said that it happened before to them and they cannot do much on it but to just order a new board.
Part Number: MSP430FR6043 Other Parts Discussed in Thread: MSP430FR6047 , TDC7200 Hello, I wish to implement a smart water-meter.
the requirements listed below :
It must be possible to measure water flow accurately 20-320 liters/h - <5% error 320…
Part Number: MSP430FR6043 Our design has conductive shielding around the transducer wires and the sensor flow tube itself (to shield the transducers). Would it be best to tie that shielding to the analog front-end ground or the digital ground? I think…