Part Number: OPA211 Hi,team,
My customer has questions about OPA211AIDR and OPA211IDR,
datasheet page 8,6.6 and datasheet page 10,6.7 about OPAx211A and OPAx211 parameters are reversed?
Normally, the suffix with A should be more advanced,But looking at…
Part Number: INA849 Other Parts Discussed in Thread: OPA211 , , TINA-TI Hi TI,
I'm doing one simulation.
I connect the circuit like below two figures.
I want to create one stable net which will generate stable current at "R3".
OPA211 is the…
Part Number: OPA2211A Other Parts Discussed in Thread: OPA211 , , OPA1632 I uesd OPA211 designed an 8 order active low pass filter which has a good performance, in order to save space on my board, i used OPA2211A ( dual channel OPA211) design this active…
Part Number: OPA211 Hello:
I am using the OPA211 low noise op amp in a low noise system where I need to use the shutdown option. I have two questions:
1. The datasheet reports that in shutdown the output assumes a high impedance state. However, since…
Part Number: OPA211 Other Parts Discussed in Thread: TINA-TI Hello All,
Why is there a mismatch between my data sheet and the simulated results? On the data sheet plot I have shown where by expected bandwidth is given a gain of 40dB. In TINA-TI simulation…
Part Number: OPA211 Other Parts Discussed in Thread: OPA1622 Hi,
In reading the document "An Engineer's Guide to Designing with Precision Amplifiers" a question has come up regarding the contribution to input offset voltage made by the PSRR of the device…
Part Number: OPA211 Other Parts Discussed in Thread: OPA365
The output of OPA211 is wrong when simulation with Pspice.
While replace it with OPA365,the result is right.
Part Number: OPA211 Other Parts Discussed in Thread: LM20 , Hi I'm looking for an equivalent foot print to the OPA211DRG in a SOT but with Rail to Rail input capability or at least 0.3V to 2.5V to cover the temperature range of an LM20. The board has…
Part Number: OPA211 Other Parts Discussed in Thread: OPA192 , TPS7A84A , LMH6629 Hi
Gain Bandwidth Product = 45MHz (G =1)
After briefly examining, the gain bandwidth product is not under expectation
Please refer to the attached ppt for more details
(1…