Part Number: OPA388 Other Parts Discussed in Thread: OPA350 , THS4281 , OPA333 , OPA328 , TINA-TI Tool/software: Hello TI support,
Can we use use OPA388 as reference buffer for 16-bit SAR ADC with 2X 10uF tantalum capacitor as its output load? If not…
Part Number: OPA388 Other Parts Discussed in Thread: TINA-TI Tool/software: Hello TI support,
There are couple of questions on operating OPA388 as attenuator in differential mode.
1. Can we operate OPA388 as attenuator (Gain=0.545) in differential…
Part Number: OPA388-Q1 Other Parts Discussed in Thread: OPA388 Tool/software: Hi we need to sense bi directional current from +/-1200A range. we looked for OPA388-Q1(In data sheet it has mention +/-1A) , Whether this is suitable for our application(Automotive…
Part Number: OPA388 Other Parts Discussed in Thread: TLV9002 , , ADS1220 Tool/software: I'm trying to build a thermometer capable of reading +/-1m°C near 0°C (it will be used to determinate the freezing point of some solutions). I'm using this https:…
Part Number: OPA388-Q1 Other Parts Discussed in Thread: OPA388 , OPA392 Tool/software: Hi,
I would like to measure 120 amperes on the shunt resistor with OPA388. When I check the op amp graph, I see non symmetrical current graphs like below. I attached…
Part Number: OPA388 Tool/software: Hello TI support,
Analog filter tool is showing attached error when launched while rest of simulation tools are getting opened. Please help.
Regards,
jagdish
Part Number: OPA388-Q1 Other Parts Discussed in Thread: OPA388 , TLV3201
Hello GPAMPs team,
my customer is interested in simulatie the High speed over current detection concept based on the application note
https://www.ti.com/lit/an/snoa987a/snoa987a…
Part Number: OPA388-Q1 Other Parts Discussed in Thread: OPA388 , OPA2388 Hi,
I would like to add overvoltage protection to the input side of OPA388. Do you have any suggestion ?
Part Number: OPA388 Hi,
I am using OPA388 in simulation and I am quite dispointed to notice that in follower configuration I obtain as low as 10kHz cut-off frequency.
Could you please tell me if this is excepted or if there might be a problem with…
Part Number: OPA388 Other Parts Discussed in Thread: OPA387
Dear team,
At datasheet, We can see difference condition of Vout range as load register value 10K or 2K ohm.
1. Is there any specific meaning of Vout range per load value in test condition…
