Part Number: OPT4048
Tool/software:
I'm working on the OPT4048 Light sensor, for light luminance and CCT values. I'm reading 0x0,0x2,0x04, 0x06 registers and conversion steps I'm following as below
I2C_TransferReturn_TypeDef ret = I2C_transaction…
Part Number: OPT4048 Tool/software: Hi Team,
When using OPT4048, the error value of the design mechanism
Please provide the minimum height of OPT404
Thanks
Part Number: OPT4048
Tool/software:
Hi Team,
Can OPT4048 meet the following requirements?
When used on AR glasses, it is required to detect distances of more than 1m and a FOV of ±10 or 30 degrees
Are there any recommended designs for convex…
Part Number: OPT4048 Tool/software: In the datasheet it has this address table,
ADDR PIN CONNECTION
DEVICE I 2 C ADDRESS
GND
1000100
VDD
1000101
SDA
1000110
SCL
1000101
VDD and SCL have the same address…
Part Number: OPT4048DTSEVM Other Parts Discussed in Thread: OPT4048 Tool/software: Dear Daniel,
I'd like to use an INT input to start a single capture at a time by syncing to a flash of light that illuminates the area to be measured. Any idea for…
Part Number: OPT4048OPT4048 is designed for LED backlight white balance monitor, now in working mode, the register data is incorrect, the detailed is as following , pls prompt advise how to debug the question, ths!
Part Number: OPT4048 Dear, the chip can trig measurement via Hardware trigger and Register trigger in one-shot mode .I see ,an I2C write to the M register triggers a measurement in Register trigger way. But I can't find M register in the datasheet. Could…
