Yes, you can evaluate this using SmartRF Studio 7 : https://www.ti.com/tool/SMARTRFTM-STUDIO
It has a range of output power settings, from +13 dBm to -11 dBm.
Regards,
Zack
Hi,
If you would like to evaluate IEEE 802.15.4 OQPSK phy, you can use Smart RF Studio 7 for this: SMARTRFTM-STUDIO-7
After you install SmartRF Studio 7, connect your LaunchPad to the computer and open the software.
You will find the CC1352P7 device in…
Hi Mark,
They should refer to SWRU321 instead and comment on USB drivers, SMARTRFTM-STUDIO version, PC OS version, and SmartRF06EB jumper positions.
Regards, Ryan
The antenna radiation pattern testing that I am referring to is for compliance/RED and other GMA style compliance testing. I know this will require CW transmit. I saw in the thread you linked that there's a reference use "radar studio". …
Part Number: SMARTRFTM-STUDIO Other Parts Discussed in Thread: CC1352R Hi all,
Why are the Sub 1GHz frequencies not available to select on 15.4 mode in smartRF Studio 7? WMCU = CC1352R
Part Number: SMARTRFTM-STUDIO Other Parts Discussed in Thread: CC1350 I am trying to connect the CC1350 Launchpad and it is not showing up on the SmartRF Studio. Not showing up in the list of connected device window. The LaunchPad was flashed again and…
Hi Rylee,
There is a LaunchPad development kit released for the CC1312PSIP (the LP-EM-CC1312PSIP), which you will need along with an LP-XDS110ET debugger board. As TheGhostOf linked to, that is the best starting point.
You can use SmartRF Studio 7 ( https…
Part Number: SMARTRFTM-STUDIO
Hi everyone,
This question might seem silly but I have to ask. I see that the txPower in dBm is 14 and for that the corresponding value seen in smartrf_settings.c is 0xA73F. The formula for power in dBm is
10*log 10 [P(in…
Part Number: SMARTRFTM-STUDIO hello
I would like to know if it's poossible, and how to flash the test configuration that run on smart rf studio, in the chip cc2640r2 embedded on my board, and let it run independantly without keeping it connected to smartrfstudio…