Part Number: SN74LVC125A Other Parts Discussed in Thread: SN74LVC1G125 Hello,
I am looking for the VOL spec for this part @3.3V/8mA. There is no data in the datasheet. Does TI have any data/curve/app note so I can find information for this? Is that same…
Part Number: SN74LVC125A Hi Team
if we have the driver which has the same drive strength and four channel, but only have 1 OE channel to control all four drive channels?
Thanks!
Part Number: SN74LVC125A Hi team
Customer want to know whether the device can generate the signal by itself to emulate the working state for aging test.
Thank you!
Best regards
Joe
24 Oct
Part Number: SN74LVC125A Other Parts Discussed in Thread: SN74HCS125 Hello Q1: My customer uses SN74LVC125A. Datasheet says input transition rise or fall rate is less than 8ns/V as follows. Is this spec applies to not only 1A to 4A but also 1OE_ to 4OE_…
Part Number: SN74LVC125A Other Parts Discussed in Thread: LSF0108 Hi,
I have a cascaded buffering scheme for SPI chip select which flows as shown below,
Micro Controller --> 1x SN74LVC125A --> 8 x 74HC154 (Demux) -->1x LSF0108 --> Destination…
Part Number: SN74LVC125A Other Parts Discussed in Thread: SN74LVC1G125 , SN74LVC07A , SN74LVC2G125 Hello TI Team,
the data sheet of the SN74LVC125A states that the maximum voltage at the output is Vo VCC+0.5V.
It further states "The input and output negative…
Part Number: SN74LVC125A-Q1 Other Parts Discussed in Thread: SN74LVC125A Hi,
The OE pull up resistor is determined by SN74LVC125A OE port sink current, please share the maximum value of the sink current or the typ pull up resistor value.
When maximum sink…
Part Number: SN74LVC125A CS1629089: RN PCU_QC Buffer_SN74LVC125ADT_ESD_Diode on the OE# pin(Pin 1,4)
Hi,
Project Name : Renault PCU
TI part Number : SN74LVC125ADT
We are using SN74LVC125ADT buffer in our RN PCU project.
SCH attached for your review…
Part Number: SN74LVC125A Hello ,
I am using SN74LVC125A as buffer in between the controller and the transistor switching circuitry. I have four channel of section where need to drive two transistor on and off. These all 8 transistor need to drive from…