Hi Martin
The OC point is likely to have 6% change when using 20k resistor. The value is from our other device's experience, the function could be similar with each other. I'm sorry for can't provide more precise data about it, it's all we have right…
Part Number: TAS5711 Hi Team,
our customer wants to use the TAS5711 in their design and has a question about the UVLO:
The d/s only states the typical value of V_UVP, see
In their system, the device is used at nominal 8V, so some concerns about the…
Part Number: TAS5711 Dears,
Could you help review TAS5711 schematic?
WB-507-TI5711.pdf
Our customer already have boards that can load at 2x15W. But Overtemperature protection of the chip is triggered after half an hour of operation.
I am happy about all…
Part Number: TAS5711 Hello,
Customer used TAS5711 for his application, stereo output, 8ohm@20W speaker, and the actual output power is limited about 6W/channel.
When it is mass of production, there is some strange sound at power up, like beep~~ the beeping…
Part Number: TAS5711 Hi Team,
Could you help review TAS5711 schematic?
TAS5711_WIFI_SPEAKER.pdf I already have boards and they work. But they can be changed, so i am happy about all your feedback. I have one problem:
When the Voltage is over 12v then i get…
Part Number: TAS5711 Hello folks,
I have a problem with the summation of the L + R channels on the sub output of the TAS5711 chip. According to the datasheet , the SUB output performs a summation of the left and right channels. And it doesn't seem to be…
Part Number: TAS5711 Hi Team,
My customer complained that TAS5711 works in PBTL mode and the product has a pop noise when starting up. the pop happens the moment when the PWM starts switching.
Is there any way to eliminate this POP noise?
Best regards…
Part Number: TAS5711 Hello everyone,
The context
To give some context, I want to connect an I2S stream from an ESP32 to a TAS57XX. I am looking for a 2.1 solution. The ESP32 can generate a master clock (MCLK) but it seems a bit unstable after watching it…
Part Number: TAS5711 Other Parts Discussed in Thread: TAS5805
Hi Sir,
My customer would like design TAS5711. however, there is pop noise on the system
so customer uses EVM to duplicate the pop noise.
While using TAS5711 EVM board, the pop noise also…
Part Number: TAS5711 Hi Ti Expert
I am using TAS5711 for our speaker product.
The original design is 2.1 mode w/ 3 speakers.
Now, we change the design to 1 SE speaker but I would't like to change schematic & PCB layout,just modify BOM to meet this change…