Tina,
The NIRscan EVM is a 4500NIR-based EVM, which comes with an associated reference design. The resources you are looking for can be found below:
www.ti.com/.../tida-00155
www.ti.com/.../dlpnirscanevm
I hope this helps.
Best Regards,
Philippe D…
Paolo,
Welcome to the E2E forums, and thanks for your interest in our DLP technology.
The DLP4500NIR DMD needs to be accompanied by the DLPC350 controller as part of a full DLP system. To faciliate design of a system using these components, we have…
Derya,
Welcome to the forums and thanks for your question. For the DLPNIRSCANEVM, only a transmissive head is shipped. There is a reflective head design which can be found here in the reference design: www.ti.com/.../tida-00155 . You would have to get…
Hello Pekka,
Welcome to the DLP Advanced Light Control section of the TI-E2E community.
The illumination/cuvette module was designed to be removable, for exactly the purpose you are asking about - removing it and replacing it with something of your own…
Hi Danielle,
Thanks for your questions and welcome to the DLP forums.
Have you seen the reference design files? We include all of the zemax optical files, CAD models, and more.
www.ti.com/.../tida-00155
www.ti.com/.../tidc293c
1. Take a look at the…
Other Parts Discussed in Thread: TIDA-00155 Hi, I am trying to establish the levels of performance of the DLPNANOEVM and the DLPNIR module TIDA-00155. The data given in the data sheets refers to a 'signal to noise' ratio - but there is no indication of…
Hi Andrea, Welcome to the DLP Forums and thank you for your question. The DLPNIRSCANEVM is capable of the range you are asking about. In the design files for the EVM we have published the design for a reflectance head which replaces the transmissive…
Hi Justin, The DLPNIRSCANEVM uses a Sitara processor running Linux to actually perform the scans and host the web interface to the device. You're able to use the Lightcrafter 4500 GUI to see NIRscan module because the Lightcrafter 4500 and NIRscan share…
Hello,
In addition to the user’s guide, I would recommend checking the reference design files ( TIDA-00155 ) to best answer your questions.
Please keep in mind that our EVMs are intended to be a starting point for designers and not end products. Given…
Hello Davide,
At this time there has not been sufficient demand to make a production run of these modules.
Please be aware that the module in question is designed to operate best with homogeneous poser samples (finely ground and uniformly distributed…