Part Number: DLP4710 Other Parts Discussed in Thread: TIDA-01226 , DLPC3479 , DLPC3439 , MSP430F5514 Dear all,
we are developing our own DLP Projector based on TIDA-01226. After minor fixed on the controller PCB we managed to start the projector (At least…
We do have a optical Design for DLP4710, you can get it here : www.ti.com/.../tida-01226 .
Currently we don't have any optical reference design for DLP470TP.
I will ask the RTIR prism information for DLP470TP to concerned team and get…
Thank you for your patience. Do you need the library file for the DLP4710 DMD or the DLPC3439 controller ?
We do not support Eagle or Altium. The design for the DLP4710 Gen2 EVM was done in Mentor PADS and the Gerber files are available in…
You should review the reference design associated with this EVM for assistance in developing your custom design:
You should also consider contacting the TI Design Network for assistance with special case system designs…
Carlos, Unfortunately the LightCrafter Display GUI is not supported on Android platforms. That being said, you should keep in mind that the USB port for the EVM interfaces with a Cypress CY7C65215 USB-Serial Bridge. If you need to interface with the…
Is this for the DLP4710EVM? if so, the mechanical design files are available near the bottom of the TI design page for this EVM. You can find it at ( www.ti.com/.../tida-01226).
I hope this helps.
Welcome to the E2E forums and thanks for your interest in our DLP products.
Have you checked the reference design we provide for the DLP4710EVM on TI.com? You can find the TI Design page and the reference schematic below:
We use multiple wires for Anode and Cathode to support the larger LED currents.
Each wire thickness is associated with a max current rating.
You basically have two options use a thicker wire or spread it through multiple wires.
Yes GPIO7 of the Cypress chip. The schematic is located under following link for your reference :
It might become handy when you start writing your own code.