Search tips
Showing 11 results View by: Thread Post Sort by

  • TL7705A: Is it OK to use the TL7705 (5V) supervisor in a 12V application ?

    TI Thinks Resolved
    Part Number: TL7705A Other Parts Discussed in Thread: TL7705 , Hello, Is it OK to use the TL7705 (5V) supervisor in a 12V application with a custom threshold by adding a resistor divider in series with the sense pin? Please review the TL7705A circuit…
    • Answered

  • TL7705B: TL7705 Difference between A, B and C

    Resolved
    Part Number: TL7705B Other Parts Discussed in Thread: TL7705A , TL7705CPS-B Dear, support Team. We received an order for TL7705C from a customer. There is no TL7705C on the TI website. However, the operation system can be ordered. What is the difference…
    • Resolved

  • the driver ability of the chip of TL7705

    Other Parts Discussed in Thread: TL7705 Now, i use the RESET/ pin of TL7705 to dirver seven AND-Gate Logic chip's input, i want to know if this can work well? you can see the picures below, we use the pin-5 of TL7705 to driver the pin-1,pin-4,pin-9,pin…

  • RE: TLC77: /RESET not going high with small current unless SENSE input is well over threshold

    Walter, I replaced the device with a TL7705 (not TLC) with 1K resistor dividers, and I removed the output chain. This doesn't behave as expected. The sense pin has 5.8V on it. However, it has the RESET pin at 2.37V and the /RESET pin is ground. Since…

  • TL7705A: TL7705A reset threshold voltage not correct at 4.55V, but only 4V

    TI Thinks Resolved
    Part Number: TL7705A Other Parts Discussed in Thread: TL7705 Hi We use TL7705A ( replace M51954A) for a dedicated CCLINK Protocol chip. The CCLINK protocol chip is effective at high level, and the delay time is 3.3ms at Min, TL7705 can satisfy this…

  • RE: TL7705A: Datasheet of TL7705A

    Yes That device is EOL. The TL7705 should keep same specs. Thanks, Abhinav.

  • TL7702B: Vit- internal circuit

    TI Thinks Resolved
    Part Number: TL7702B Other Parts Discussed in Thread: TL7705B , TL7733B , , TL7705 , TPS3808 , TPS3890 Hi, Could you please give me advice about TL7702B, TL7705B and TL7733B? My customer would like to adjust voltage divider rate which consists R1…

  • TL7705B: Resistor Tolerance

    TI Thinks Resolved
    Part Number: TL7705B Other Parts Discussed in Thread: TL7705 , TL7715A , TPS3700 , TPS3702 , TPS3701 Hi, We use the TL7705B to monitor a couple of 5V rails and would like to adapt it to monitor a 15V rail (the TL7715A doesn't have the needed temp range…

  • Question about Relational expression of Vref and VIT- (TL7705A)

    TI Thinks Resolved
    Other Parts Discussed in Thread: TL7705A , TL7705 On attached TL7705A datasheet P2, writing about Internal resister of SENSE-Pin. TL7705ACP.pdf I substituted and calculated Vref：2.48V～2.58V (and TL7705's R1,R2). As a result, VIT-：4.41V～4.59V. …

  • TPS65140: TPS65140: DMD_PWR_EN pulls high, the P5V is pulled down, resulting in a drop in the input 5V voltage.

    TI Thinks Resolved
    Part Number: TPS65140 Dear all， Attached is the schematic diagram. On page 5, it is the circuit diagram of TPS65140. The following is the screenshot.Arrow P5V is 5V power input, output VOFFSET, VRST, VBAIS and P3P3V_TPS. The power chip enable pin is…

Didn't find what you are looking for? Post a new question.