Part Number: TLV3202-Q1 Other Parts Discussed in Thread: TLV3202 How to design TLV3202 with ac hysteresis ? Are there any reference documents available ?
Part Number: TLV3202
Hello experts, I have question about equation (4) in datasheet P14. "Vin1 = R1 x Vref / R2 x Vref" is correct equation? It should be "Vin1 = R1 x Vref / R2 + Vref "? Thanks and best regards, Ryo Akashi
Part Number: TLV3202 Hi Team,
I understand TVL3202's Vcm is Vee-200mV to Vcc+200mV. Our customer intends to use single supply (+5V Vcc and 0V Vee), and have TLV3202 in a window comparator configuration detecting voltages outside the range of 0-5V.…
Part Number: TLV3202 Other Parts Discussed in Thread: TLV3201
Hi,
I am doing the simulation with TLV3201.
IN+: Pulse signal with 2MHz
IN-: Vref at 2.5V
Following hysteresis setting on datasheet Figure 29.
The output result is giving unexpected output…
Part Number: TLV3202-Q1 Other Parts Discussed in Thread: TINA-TI Jose Maroto Could you please support on this request ?
Need unencrypted Model for TLV3202AQDGK*Q1
Thank you,
Othmane
Part Number: TLV3202-Q1 Other Parts Discussed in Thread: TLV3202 , TLV9032 , TLV7032 , LM393LV
Hi
below is the circuit, during test, TLV3202 is easy to be damaged, mainly focus on pin 3, when pin 7 output 5V, pin 3 is 1.69V or 3.72V, it is 5V for good board…
Part Number: TLV9062 Other Parts Discussed in Thread: TLV9061 i want to simulate the TLV9062 OP AMP with 3.3v I did not find this model in pspice could u please suggest these model
Part Number: TLV3202-Q1 Other Parts Discussed in Thread: TLV3202 Hi team,
I have an issue in using TLV3202 as a comparator. While testing I supply Non inverting input (IN+) with frequency signal of 50% duty (Typically fat Low - 0V to High-3.3V levels)…
Thanks for response.
The incoming signal is square wave.
supply voltage is 3.3V.
Are you suspecting this because of speed limit in TLV3202 device.
Reference voltage is fixed one verified no distortion.