Part Number: TLV320AIC3120EVM-U Other Parts Discussed in Thread: TLV320AIC3120 Hello,
I'm evaluating the TLV320AIC3120 for use in a wearable voice-amp application. My intended topology is to use a dynamic microphone-->TLV320AIC3120-->8 ohm speaker…
Part Number: TLV320AIC3120EVM-U Hello - I am attempting to talk to the CODEC registers directly using a bus pirate connected to the SDA and SCL lines on the eval board. I am issuing the commands to read a register, however I always receive an 0xFF as…
Part Number: TLV320AIC3120EVM-U Other Parts Discussed in Thread: TLV320AIC3120 Hello,
I'm using the TLV320AIC3120 as a microphone amplifier. I have D5 of register 29 on page 0 set so that the ADC data is looped back into the DAC, allowing the mic signal…
Part Number: TLV320AIC3120EVM-U Other Parts Discussed in Thread: TLV320AIC3120 We are using TLV320AIC3120EVM-U connected to SDTM32MP135-DK.
Only the speaker is connected to LV320AIC3120EVM-U, no microphone is used.
The connections are below:
We have the…
Part Number: TLV320AIC3120EVM-U Other Parts Discussed in Thread: TLV320AIC3120 , TLV320AIC3100 Hello everyone,
We have purchased a TLV320AIC3120EVM-U evaluation board to test the audio chip for future product development.
Since we don't need the miniDSP…
Part Number: TLV320AIC3120EVM-U Other Parts Discussed in Thread: TLV320AIC3120 Hi,
Currently I am having TLV320AIC3120EVM-U evaluation kit, in which I wanted to configure the clocks and audio interface as per custom board requirements and play the audio…
Part Number: TLV320AIC3120EVM-U Other Parts Discussed in Thread: TLV320AIC3120 The icons in the init script dialog are not enabled/ highlighted after connecting the EVM to the PC via USB.
Please suggest me the solution.
Thanks in advance.
Part Number: TLV320AIC3120EVM-U
1. We are not able to program Noise threshold and target, is there any way?
2. Record option greyed out in our Eval board.
We wanted to record audio and Evaluate Different Microphones by seeing their frequency response…
Part Number: TLV320AIC3120EVM-U Hi,
We wanted to Interface I2S, I2C, and GPIO1 Between FPGA Board EVM.
This post: e2e.ti.com/.../tlv320aic3120evm-u-using-tlv320aic3120evm-u-with-an-external-mcu
Suggests that I2S traces must be cut in order to test I2S. …
Part Number: TLV320AIC3120EVM-U
If I insert OMTP Headset in J4 will i be able to use use both speaker and mic of the headset? in other words, will i be able to talk and hear on headset?
Or should we use only headphone as mentioned in schematic?