Part Number: TMDSCNCD28379D Other Parts Discussed in Thread: SYSCONFIG I have generated code using Simulink and have it opened in CCS. What I want to do now is to use SysConfig for the rest of the development. How can I get SysConfig to recognize the…
Part Number: TMDSCNCD28379D Other Parts Discussed in Thread: C2000WARE Hi, We are using this TMDSCNCD28379D Control card. We are able to connect and able to flash the code. But the problem we're facing is that we're not able to debug our project code…
Part Number: TMDSCNCD28379D Hello TI Team,
I have created a board using TMS320F28386SPTPQR micro-controller. I wanted to know if I can use debugger from the TI TMDSCNCD28379D (F2837x controlCARD Rev 1.3) to connect with TMS320F28386SPTPQR micro-controller…
Part Number: TMDSCNCD28379D Other Parts Discussed in Thread: C2000WARE I have a TMDSCNCD28379D controlCard with a docking station. I am using CC 12.3.0.00005.
I am trying to get the C:\ti\c2000\C2000Ware_4_03_00_00\driverlib\f2837xd\examples\cpu1\usb\usb_ex7_host_msc…
Part Number: TMDSCNCD28379D Other Parts Discussed in Thread: C2000WARE Hello,
I am trying to get the USB bootloader example working - C:\ti\c2000\C2000Ware_4_03_00_00\utilities\flash_programmers\usb_flash_programmer. I have read through some of the other…
Part Number: TMDSCNCD28379D Other Parts Discussed in Thread: SYSCONFIG In the C2000 training lab. the ipc lab, for the CPU2, In the main function, there is a sentence for initializing the IPC interrupt. "// Enable IPC0 interrupt. IPC_registerInterrupt…
Hi Chris,
I am sorry for the late reply.
CHRISTOPHER YECKEL said: Above you state " Usually it starts from the IO pin to CMPSS module(usually for current protection) to EPWM trip zone. If you still see the trips happen. it can be any issue along this…
Hi Siddharth,
With you stating that you were using the same steps, application, and hardware, the only difference I could see was the actual USB Flash drive. I found another one and your test case now works.
My USB firmware update with the USB Flash …
Part Number: TMDSCNCD28379D What steps must be taken to use the virtual COM port of the XDS100v2 to communicate with the MCU over the UART interface, but without running Code Composer Studio?
Present status:
after device programming from CCS, PC<->MCU…