Part Number: TMDSIDK437X Other Parts Discussed in Thread: UNIFLASH , AM4379 Hi everyone,
I am trying to flash my AM437x Industrial EVM through XDS100V2 USB to QSPI.
Software and tools are used:
- CCS Ver 11.2
- uniflash_8.0.0
- Command line
Hardware:
AM437x…
Part Number: TMDSIDK437X Other Parts Discussed in Thread: TMDXSK437X , AM4376 , , TPS5402 There is TMDSIDK437X and TMDXSK437X as EVMs for AM4376, and I’ll be calling those as IDK and starter kit, respectively.
Powering
IDK: It seems to be impossible…
Part Number: TMDSIDK437X Other Parts Discussed in Thread: SYSCONFIG Hello,
I am working on BSP for IDK4376.
is the below uart1 padding configuration for idk4376 board is ok?
uart1_pads: uart1pads { pin-set = < 0x980 0x13070000 /* PIN_UART1_RXD */ /* CTRL_CONF_UART1_RXD…
Part Number: TMDSIDK437X Other Parts Discussed in Thread: UNIFLASH ,
Hello,
I have a issue when trying to flash the QSPI-flash on the TMSIDK437x. I tried the following steps with uniflash 7.0 and 6.4 on two different TMDSIDK437x (one just arrived today…
Part Number: TMDSIDK437X Hello,
I have sign NDA and i have secdev package.
I can see AM437x_secure_boot_overview_training
but i can not hear that.
Can you provide any help?
Regards, Vrund
Part Number: TMDSIDK437X Hello,
I am using IDKAM4376 board.
i am able to boot the board.
1) How to check uart from console?
2) what are important command that i can use?
3) How would i add UART1 driver to dts file?and how to test that?
Regards,
Vrun…
Part Number: TMDSIDK437X Other Parts Discussed in Thread: AM4376 hello,
I am working on AM4376 board.
Is there any UBOOT either binary or source code available for IDK4376 board?
regards,
Vrund
Part Number: TMDSIDK437X Other Parts Discussed in Thread: AM4372 Hello,
I am working on TI IDK4376 board.
I am testing UARt1.
I am using Vxworks oS.
I am able to write to the UART1.
But as soon as i send single char from PC utility to UArt1 board reset…
Hi Team,
I am looking at the address where .cint_00 resides.
in the cfg I found Program.sectMap[".c_int00"].loadAddress = 0x80000000;
in the map file , indeed cfg is at that address
when I edit the cfg file and change the address , and re-build m the map…
Part Number: TMDSIDK437X
Hi Team,
I am trying to re-start an application that is already on the DDR.
looking at the SBL code , it seems that after the DDR copy , the SBL simply jumps to the entry point (Address is 0x8000 0000)
If I just have my application…