Part Number: TPS1210-Q1 Hi Team,
We are using the TPS1210 as a load switch for a PWM load. Note that the TPS1210 itself is not being PWMed, the supply (DIN) into the TPS1210 controlled FETs is being PWMed. Because the BST capacitor is connected to SRC…
Part Number: TPS1210-Q1 Hi,
I have to design charging/discharging circuit with protection like battery short, charging low voltage, over voltage, etc and battery percenatge, low cost solution.
I have battery of 3.7V 15AH.
Regards,
Anurag
Part Number: TPS1210-Q1 Hi expert,
I would like to use the TPS1210-Q1 for a pre-charge application, where the SRC pin will be high for long periods of time. Is the charge pump for the bootstrapped supply able to supply enough energy if the SRC pin is…
Part Number: TPS1210-Q1 Tool/software: Hi expert,
My customer (CosMX) is using TPS1210-Q1 and INA186A1-Q1 in 12V BMS project at the same time. And TPS1210-Q1 and INA186A1-Q1 share the same RSNS (Shunt resistor) as below show. R&D found the Gain of INA186A1…
Part Number: TPS1210-Q1 Tool/software: Hi expert,
My customer CosMX want to disable the short circuit protection in some situations. So they want to use a MOSFET to short the TMR to GND when they want to disable the short circuit protection, but the…
Part Number: TPS1210-Q1 Tool/software: Hello,
We're using 2 of the TPS1210 in a system in parallel.
What we think we're seeing is a capacitive coupling between the active and in-active channels G1, G2 and SRC.
Adding a 100K resistor from G2 to…
Part Number: TPS1210-Q1 Tool/software: Hi expert,
There is a Latch-off issue of SCP in CosMX MP project, please help to analyze.
For the MP samples of TPS1210-Q1 in same project board, the INP need to be pulled low twice to reset the latch.
…
Part Number: TPS1210-Q1 Tool/software: Hello team,
My customer wants to use TPS12100-Q1 for 12V BMS, here are several questions:
1. Can it support bidirectional current? In the BMS, both discharge and charging are needed. Is there a logical conflict…
