Part Number: TPS2595 Other Parts Discussed in Thread: TPS2117 ,
Tool/software:
Hello,
I have a 2 DCAP3 buck regulator, one for 3.3v and one for 5v. I hooked their input to TPS2117 power selector IC but this IC is limited to 4 amps while buck regulators…
Part Number: TPS2595 Tool/software: Hello,Teams
Could you please tell me about the Tsc of the TPS2595xx? The datasheet says Type 5us. The min and max values are fine for the device design, so could you tell me? Typ 5us ± 5%? ±10? I apologize for the…
Part Number: TPS2595 Tool/software: In the d/s, it addresses the ILM offers dual function of the current limit and monitor.
Customer would like to use this pin for output current monitor. it means it would be connected to the ADC of the MCU for current…
Part Number: TPS2595 Tool/software: The eFuse TPS259520 shows an undesirable behavior when switched on.
IN: 3.3V (the blue curve) OUT: (the magenta curve) current: (yellow curve)
When the 3.3V is switched on, the current pulses at Vmin(2.7V) and…
Part Number: TPS2595 Other Parts Discussed in Thread: TPS2597 , TPS25981 , TPS22811 Tool/software: HI
We need the load switch with the below specs for the laptop display with active high enable pin.
Operating voltage: 8: 14V
Current Requirement…
Part Number: TPS2595 Tool/software: Hi Team，
The customer's board has multiple memory disks, and they are concerned that when a memory disk is inserted into the slot, an overvoltage will be generated on the output side of the efuse. Therefore, want…
Part Number: TPS2595 Tool/software: Dear Designer,
My customer encountered a problem when using Ti's efuse chip TPS259540DSGR, which is described as follows. In the figure below, when J2 inputs 13.1V DC, the D20 LED light is on. At this time, the output…
Part Number: TPS2595 Tool/software: Hi,
When I read through the datasheet, there are multiple locations mentioned the CIN recommendation:
1. The TPS2595xx devices are designed for a supply voltage range of 2.7 V ≤ VIN ≤ 18 V. An input ceramic bypass…
Part Number: TPS2595 Hi team,
can you please provide the correct pSpice model for TPS259573 device. I checked in the website it is shown differently behaviour and it pspice is written for UVLO instead on OVLO.
where as datasheet shows as below…
