TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel


Search tips
Showing 41 results View by: Thread Post Sort by
  • TPS54528: SW short to GND issue and Schematic review

    Robin Yu
    Robin Yu
    TI Thinks Resolved
    Part Number: TPS54528 Hi team, It is already found about 10pcs among 20kpcs failed during production for TPS54528. All of the are found SW short to GND even when the load is very small, only tens of mA. Could you please help check the sch and layout…
    • over 6 years ago
    • Power management
    • Power management forum
  • Answered
  • TPS54528: About Bootstrap & REG5 Capacitor

    Hide
    Hide
    Resolved
    Part Number: TPS54528 Other Parts Discussed in Thread: TPS54227 Hi Jason-san, I would like to know a recommended minimum effective capacity value of Bootstrap & REG5 Capacitor. Could you please let us know if you have any information? And, if…
    • Resolved
    • over 7 years ago
    • Power management
    • Power management forum
  • Answered
  • RE: TPS54528: Is the TPS54528 stable with more than 200uF on the output?

    JohnTucker
    JohnTucker
    Resolved
    Make sure to place a zero ohm resistor between Vout and the upper FB resistor. That will provide a convenient place to break the loop for measurement. We replace the 0 ohm with 50 ohm to interface our network analyzer during testing.
    • over 8 years ago
    • Power management
    • Power management forum
  • RE: TPS54528: Maximum Power Capability

    Iven Su
    Iven Su
    Hi, Not correct. As marked on the title, the TPS54528 is designed to provide up to a 5-A output current in the following range. The section may need an update.
    • over 7 years ago
    • Power management
    • Power management forum
  • About TPS54528 audio noise issue

    Kuo Nowal
    Kuo Nowal
    Other Parts Discussed in Thread: TPS54528 Hi Sir, My customer simulate TPS54528 on TI's EVM board, but have one issue, at 20mA load occur audio noise, source from inductor, waveform as below FIG. Green is current Blue is PWM Currently increase inductance…
    • over 9 years ago
    • Power management
    • Power management forum
  • Answered
  • TPS54295 and TPS54528 - VREG5 when Vin is less than 5V

    Hirotaka Matsumoto
    Hirotaka Matsumoto
    Resolved
    Other Parts Discussed in Thread: TPS54295 , TPS54528 Hi all Would you mind if we ask TPS54295 and TPS54528? How much is VREG5 when Vin is less than 5V? Will it be 5V? (VREG5 is typ 5.5V in case of 6 V < VIN < 18 V) We need your help always. Kind regards…
    • Resolved
    • over 8 years ago
    • Power management
    • Power management forum
  • TPS56528: TPS56528 vs TPS54528 what is "Advanced" Eco-mode vs Eco-mode in the two chips

    Marek Roszko
    Marek Roszko
    TI Thinks Resolved
    Part Number: TPS56528 Other Parts Discussed in Thread: TPS54528 , The two chips mentioned in the title have near identical datasheets except one of them, the TPS56528 is labeled "Advanced eco-mode" and the other is just "Eco-mode". The only difference…
    • over 8 years ago
    • Power management
    • Power management forum
  • Answered
  • TPS54528 drop out voltage, Vout=5V

    Peter Olufson53
    Peter Olufson53
    Resolved
    Other Parts Discussed in Thread: TPS54528 Can you tell me drop out voltage for TPS54528 with Vout=5V? Can't find the answer in the datasheet.
    • Resolved
    • over 10 years ago
    • Power management
    • Power management forum
  • Answered
  • TPS54528 Gain Phase

    KIYOSHI NARISAWA1
    KIYOSHI NARISAWA1
    Resolved
    Other Parts Discussed in Thread: TPS54528 Dear TI Is there any bode plot data with 68uF Cout or 22uF x 3pcs for TPS54528? Customer 'd like to know the gain phase. Conditon of Vin and Vout are depends on your data. narisawa-k@clv.macnica.co.jp …
    • Resolved
    • over 11 years ago
    • Power management
    • Power management forum
  • Answered
  • TPS54528 / Question about Psi-jt

    S.Satoshi
    S.Satoshi
    Resolved
    Other Parts Discussed in Thread: TPS54528 Hi Everyone, Please let me ask about Psi-jt of TPS54528. Please let me know the test environment when Psi-jt was measured. Specifically our customer is asking the airflow condition and PCB used at testing…
    • Resolved
    • over 10 years ago
    • Power management
    • Power management forum
<>

Didn't find what you are looking for? Post a new question.

  • Ask a new question