Part Number: TPS563208 Hi Team,
My Customer used JW5060 for the MCU aux power, but there has some ripple noise issue in light load,
they do not need the skip mode or burst mode in light load or no load, the TPS563208 (Continuous Current Mode) cant be reduced…
Part Number: TPS563208
Hello there,
I am trying to calculate the maximum output voltage ripple for a device using the TPS563208. I need to know, how to optimize the output capacitors value for the given (known) maximum load, inductor value, and input…
Hi Robin,
It will be better if you use TPS563208 which works in FCCM mode.
The enable or disable of the IC is decided by the voltage on EN pin instead of the resistor in fact.
Thanks.
Shipeng
Part Number: TPS62A02 Other Parts Discussed in Thread: TPS563208 Hi team,
Do we have the similar spec of TPS62A02 but with the same external circuit of below picture of SOT-23-THIN package? Customer want to do drop in replacement of TPS563208 with smaller…
Part Number: TPS563208 Hello,
Thanks for your attention.
We have seen if we didn't put 0.1uf cap near EN pin of TPS563208, when pull up voltage(12V) rise from 0V, the EN will have ringing as figure below, if the 12V rail is not rise start from 0V, the…
Part Number: TPS563201 Other Parts Discussed in Thread: TPS563208 Hi
I read the datasheet of TPS563201. However I do not understand what is the difference of the both device (TPS563201 and TPS563208).
As it's mentioned at the datasheet, the both device…
Part Number: TPS563201 Other Parts Discussed in Thread: TPS563208 , TPS563200 Hi
#1
I need to design a 12V DC input and output will be 4V /2~3A buck , so i would like to choose either TPS563201 (light load at Pulse-skip mode ) or TPS563208 (CCM) ;But I…
Part Number: TPS563208 Hi, Team,
We have questions for TPS563208. There is Vout > Vin condition on the customer board. Please refer the below blocks.
1. Is it ok to use TPS563208 in this condition?
2. Should they use discharge register? Or should they…