Part Number: TPS56837 Other Parts Discussed in Thread: TPS54821 Tool/software: Hello,
I would like to use a TPS56837RPAR for our new design.
V in is 15V, V out between 3.5V to 12.5V, adjustable using a DC voltage between 0 (12.5V) and 3V (3…
Part Number: TPS56837 Hi
The circuit diagram was designed with the following specifications.
-spec-
input: 10.5~16.8V
OutputL 5V 8A
Please review it.
Thanks
Part Number: TPS56837 Hi team,
May I know how I estimate Tj by using effective RθJa? Based on the Tj calculation in spra953c.pdf, calculated Tj exceeds absolute maximum rating of Tj of TPS56837.
Customer's use case:
Vin: 24V
Vout: 12V
Iout…
Part Number: TPS56837 Hello team,
My customer would like to use TPS56837 with 24Vin -> 12V / 4A output. But this device is designed for output up to 13V. Is it safe to use in 12Vout configuration?
I think the minimum ON time and minimum OFF time for…
Part Number: TPS56837 Hello team,
I would like to set the switching frequency of TPS56837RPAR to 800kHz and ILIM=7.2A. According to datasheet Table 6-1. MODE Pin Setting, 102kΩ is required. Is there no problem with this combination of 100kΩ + 2kΩ resistors…
Part Number: TPS56837 Hi team,
If the PG terminal is not used, is it okay to leave it open?
The datasheet mentioned "recommends a pullup resistor of 100kΩ to pull the PG pin up to 5V voltage" . How is it In case when PG terminal is not used?
Regards…
Part Number: TPS56837 According to TPS56837 datasheet, the output voltage range is 0.6-13V. What is the reason why the maximum output voltage is limited to 13V?
If the load current is small, can the maximum output voltage exceed 13V?
Part Number: TPS56837H Other Parts Discussed in Thread: TPS56837 Hello,
As a part of a power charging board I'm designing now I need to use the TPS56837H for converting 24v to 15v. .
Till now I considered working with TPS56837H since its data-sheet…
