Part Number: TPS61093-Q1 Tool/software: Kindly help here to review the below attached schematic design pdf of 9V0 boost regulator part (TPS61093QDSKRQ1) from TI. please provide your valuable feedback on the same.
TPS61093QDSKRQ1 9V0 Boost.pdf
Part Number: TPS61093-Q1
Hi Team,
Could you share a transient SPICE model that works with SIMetrix tool.
Also is there a SIMPLIS model or a small signal model for AC analysis?
Regards,
Mithun
Part Number: TPS61093-Q1 What is the min or max soft-start time supported by the IC.
Can the soft-start time reach as high as 100ms, if I put a 1uF cap on the SS pin?
Best Regards,
Mithun
Part Number: TPS61093-Q1 Hi team,
My customer acceptable for voltage fluctuation on TPS61093-Q1.
In datasheet, voltage changes nearly 500mV when load change.
Is there any way to suppress this fluctuation?
Regards,
Youhei MIYAOKA
Part Number: TPS61093-Q1 Hi team,
My customer have questions about 9.2.1 15V Output Boost Converter in datasheet.
1. How much RV required for C3.
2. Is it possible to add snubber circuit even diode integrated.
3. In 7.3 Recommended Operating Conditions…
Other Parts Discussed in Thread: TPS61093-Q1 Hi
My customer will use TPS61093-Q1 under Vin=3.3V, Voiut=5V.
But calculation method of Iout_max isn't written in that datasheet.
Are there the reference materials or calculation methods of Iout?
…
Other Parts Discussed in Thread: TPS61093-Q1 Hi
The datasheet of TPS61093-Q1 is written that Ta and Tj is -40 ~-125℃ in "7.3 Recommended Operating Conditions". But when Ta was 125℃, I think Tj is over 125℃. So, is this case out of recommending operating…
Hi Helen,
Thank you for four support.
Customers use for Automobile.
The TPS61093 is a 1.2-MHz, fixed-frequency.
Since it is caught in the radio band, TPS61093-Q1 can not be used.
You wrote like this in the past.
A:When Vin=3.06 to 5.33V, Vo…
The application is a battery-powered consumer measurement device which also has health and law enforcement uses. Input to the boost converter is a single Li-ion cell, and the output is 16 V @ 100 mA or sometimes more. The load is an OLED display, so the…
Hi Cho,
Q1--> TLV61046A can not output 55 to 60mA with the conditions you provided.
Q2-->For Vin 1.8V to Vout 16.5V with Iout 55mA ~ 60mA, TPS61093 can be the available option. Please check whether it is applicable to your applications. If not, we…
