Part Number: TPS62163 Other Parts Discussed in Thread: TPS62162 I am trying to use a TPS62163 Input voltage 12V output 5.0V 200mA, I found the circuit works OK with an input voltage of around 7 Volts, if I increase to 12v the chip fails (overheat, and…
Part Number: TPS62163 Hi team,
I see there is a Initial output voltage accuracy data in the datasheet. I'm not very sure what the data mean here. Is it the accuracy of the internal reference voltage?
Part Number: TPS62163 Other Parts Discussed in Thread: TPS62162 I cannot find the drop-out voltage in the spec. It says that it'll run up to 100%, which implies a very low dropout voltage, approaching 0. I need a 5V supply with a Vin down to 5.5V…
Part Number: TPS62163 Other Parts Discussed in Thread: TLV62130A Hello,
I have a question for TPS62163 regarding output discharge function.
TI.com's list of DCDC said TPS62163 has output discharge function. However there is not on datasheet.
I found…
Part Number: TPS62162 I have been having odd problems with my two VREGs, this is related to the post I made previously. Anyways, my layout was not the problem, which was a theory I was little skeptical of given the symptoms. I assembled my new board and…
Part Number: TPS62163 Other Parts Discussed in Thread: TINA-TI , Tool/software: TINA-TI or Spice Models Hi,
Customers are trying to make inverting circuits using TPS62163. Customers are considering circuits like the following materials.
Http://www.tij.co…
Part Number: TPS62163 Other Parts Discussed in Thread: TPS62150A Hi,
Does TPS62163 have output discharge function?
I found "Outout discharge" wrriten on ESP,but it was not written in block diagram.
Could you tell me about this?
Best Regards,
Yuto…
Part Number: TPS62163 Hi,
Could you let me know Dead time for switching and Low side-FET Vf voltage of TPS62163, please? My customer has a question about below picture. This is SW pin waveform. Customer wants to know if it is problem that voltage drop…
Part Number: TPS62163 I have designed a TPS62163 5 V buck converter into a new product that I am currently testing. I have determined that plugging in a power cable consistently causes the chip to become damaged and stop functioning properly.
I just finished…
You recommend put the schottky diode between Vout and GND in application note "SLVA469C" Can we remove this diode if Vin ramp rate is slow?
Best Regards, Kohei Sasaki