Part Number: TPS62821 Dear Sir,
Please help to check below waveform about TPS62821 Vout and Iout. Is it normal for the output voltage to rise again after falling? Is this the behavior of the switching current limit?
Best Regards,
Sam
Hi,
For the TPS62821 the SW pin is between the VIN and PGND pins, so the input capacitor blocks access to the SW pin unless the SW pin is routed underneath the input capacitor.
More information about your particular question you can find in the following…
Part Number: TPS62822 Other Parts Discussed in Thread: TPS62823 , , TPS62821 We have a requirements for TPS62822/ TPS62823/ TPS62821 parts. As suggested by Excel Regidor in my earlier query, I have the get notifications option on TI store enabled, but…
Part Number: TPS62821 Dear E2E:
Compared to the schematic and pcb layout, i found the via near L99 in wrong position, i should be behind the output cap C741. The input cap C739 was not very perfecter.
I check the sw waveform, it's bad. The output…
Part Number: TPS62821 Hello,
In my configuration, EN pin is shorted with VIN pin, as shown in the figure.
For contacting issues in my prototype, it is possible that the 5V line suddenly becomes an open circuit, bringing VIN and EN pin to ground…
Part Number: TPS62821 Other Parts Discussed in Thread: TPS61291 , TPS62740 , TPS62745 , TPS61099 Can we use two TPS62821 to step down two primary lithium batteries from 3.6V to 1.6V and then add them up to have regulated 3.2V output?
Part Number: TPS62821 Other Parts Discussed in Thread: TPS62740 , , TLV62565 Hello Sirs,
We evaluate tps62740 for low power products but its output voltage will become Vin during
output pre-biased . Is this reasonable for this chip ?
We consider…
Part Number: TPS62821 Hello team,
Hope you are doing well. When you get a chance can you help with customer question on if the TPS62821DLC has a 1.2V Fixed version?
Regards,
Randhir
Part Number: TPS62821 Hi,
I didn't find the measured output ripple in datasheet. Could you pls provide the ripple data with below condition? Thanks.
Vin=3.3V Vout=1.5V Iout=50-300mA L=0.47uH Cout=22uF
Part Number: TPS62821 Hello,
On my design the enable pin of the buck converter TPS62821 is controlled by a µC, but before the µC is programmed the EN pin is leave floated and VIN is powered.
During this time, the output of the buck converter is probably…
