Hello,
I would recommend adding a 3rd pin for GND if using the USB2ANY.
N2510-6002-RB is the 10 pin header used on the TPS650860 EVM which works with the ribbon cable provided with USB2ANY; I would recommend utilizing it if you have the space on your…
Part Number: TPS6521815 Other Parts Discussed in Thread: TPS65217 , TPS65216 , TPS65218 , TPS650861 Hi -
I'm looking for a PMIC that has:
at least 3 Buck outputs with voltage ranges from 0.6V to 3.3V, output currents in the range of 2-3 Amps.
…
Hello JH,
I do not see any issue with that approach, though I have three comments:
LDOA2 won't turn on by default, so just clarifying that if they are using it to enable an external LDO, it would need to be controlled by I2C
Otherwise if they…
Prahlad,
The TPS65086 would be a good option for these requirements. It has three BUCK controllers which use external FETs, so as long as they FETs are sized appropriately it can support 0.9V @ 3.8A continuous.
Something to also consider would be…
Part Number: TPS650864 Other Parts Discussed in Thread: TPS650861 Hi,
I would like to understand further on the CTL pins for the bootup sequence in TPS65086401.
FPGA device to be powered is Xilinx Zynq Ultrascale+ ZU3CG.
The power up sequence is…
Hi Derek,
The drivers for TPS650864 are located here: http://www.ti.com/tool/TPS65086SW-LINUX
If you would rather use a device that is pre-programmed for your use case you can use a TPS650861 device. Arrow can provide programming for this device.…
Hello,
Depending on your exact power requirements we can recommend using TPS650861/TPS650864x devices, TPS65023, or TPS65218. Do you have any information on what you will need?
Best regards,
Layne J
Darren,
The TPS65086x family of devices is the best fit for the Virtex Ultrascale+. Unfortunately we do not have a spin of this device targeted specifically at the Virtex devices, but we do have a user-programmable version of this device, TPS650861…
Hi Gareth,
Thanks for reaching out! I think you had previously submitted an E2E with the same question and its currently waiting for your response ( Link to previous E2E ). Pease note the Buck6 output voltage is not the only difference between TPS650942…
Hi Xiao,
For the TPS6508640, the CTLx settings are fixed in the 0x38 address. The registers in this address are set to work with the processor attachments in the picture you shared and we do not recommend changing them.
For custom programs, I recommend…
