Part Number: TPS82130
Hi Team,
My customer is making the Thermal evaluation,
We know we have shown the Tj Recommended Rating 110C in the datasheet, but how about the Tcase Recommended Rating ?
Can we provide that or we have a general reply for…
Part Number: TPS82130 Other Parts Discussed in Thread: TPS62913 Hi,
I am considering using this part in my application and noise is critical to my design. Can you please share any performance data or results with respect to PSRR and EMI?
Thanks &…
Part Number: TPS82130 Dear TI Team,
we had some defects on the EN pin of the TPS82130 device. We reckon it comes from the VIN+0,3V abs-max-rating in the datasheet. We do not fulfil this rating, because there is a 100nF capacitor next to the pin.
Is…
Part Number: TPS82130 Can VOUT be output when EN voltage reaches 0.9V? For example, is it OK if the EN voltage is 1V?
About TPS82130.pdf 6.5Electrical Characteristics LOGIC INTERFACE (EN)
Is VIH Typ 0.65 correct?
Part Number: TPS82130 Hi,
Please see below waveform which is current limit test.
Look like the device current limit behavior is hiccup, but I can't find related description in datasheet.
Could you please confirm the current limit behavior? And what…
Part Number: TPS82130 Other Parts Discussed in Thread: TIDA-01457 , TIDA-01405 Hi,
Is it possible to use the TPS82130 (TPS821x0) in an Inverting Buck-Boost Topology like in this application report: http://www.ti.com/lit/an/snva882/snva882.pdf
Checking…
Part Number: TPS82130 I am concerned about regulation due to distribution loss in the copper plane. I would like to move the voltage sense location, which is right at the output of the VRD, to the middle of the load area. However, I have a concern about…
Hello team, The customer have a question about the specification of switching frequency. What is the minimum and maximum switching frequency in the following case of the datasheet?
Your advice is appreciated.
Best Regards, Akihisa Tamazaki
Part Number: TPS82130 Hi
I have a question about UVLO of TPS82130.
If TPS82130 is shut down by UVLO, does this device restart operation over Vin=2.9V(typ)?
Best regards,
Yokota
Hi Bob,
We confirmed that there is an issue with the model which is causing the difference between correct soft start based on datasheet equation and what the simulation results are showing. At this time I cannot comment on when the model will be fixed…
