Part Number: TPS929240-Q1 Tool/software: 1.The official routine I transplanted, tps929240, and the pictures are all data sent by my MCU, but the tps929240 IC did not respond. All three address pins of the hardware are grounded. 2. FS0 and FS1 ports are…
Part Number: TPS929240-Q1 Tool/software: Hi team,
The customer would like to know why frame loss occurs in the TPS929240 while the TPS929120 functions normally under the same settings. ( 1Mbps, DBWTIMER = 1ms )
What differences between them could…
Part Number: TPS929240-Q1 Tool/software: Hi team,
If one TPS929240-Q1 is used to control all 24ch PWM brightness, can only one frame be sent? Or need to be sent in multiple frames? Thanks.
Regards,
Ivy
Part Number: TPS929240-Q1 Tool/software: Hello,
I am using your sample code for TPS929240, and i traying to create open circuit with the help of TPS929240 eval board.
But FLag_ERR register one bit is there for Flag_OUT this bit is not set but flag…
Part Number: TPS929240-Q1 Tool/software: We are using TPS929240 to make a headlamp scheme;
When communication interruption is required, the chip output is turned off.
Since the chip watchdog is turned off by default, the watchdog needs to be turned…
Part Number: TPS929240-Q1 Tool/software: Hi team,
The customer is simulating loss of communication by testing as follows：
Watchdog time is set to 500ms, FS mode to illuminate the LED.
A. When CAN-H shorted to CAN-L , the 929240 enters FS mode. …
Part Number: TPS929240-Q1 Tool/software: Hi TI team,
when we receive the cargo, we find that the outer packaging is not completely vacuum, see the photo below:
While it is MSL3 material, is it OK to continue to use them for production?
Thank you…
Part Number: TPS929240-Q1
Tool/software:
Hello
I want to burn EEPROM through the SUPPLY GND RXD TXD four pins.
question1：What range should the power SUPPLY voltage be in order to burn normally?
question2：Why does the light turn on during the…
