Part Number: RF37S114 Other Parts Discussed in Thread: TRF7960 , TRF7960A , TRF7970A Hi,
I am trying to get a board working that is equipped with a TRF7960ATB evaluation module, to read and write RF37S114 transponders. Communication with the TRF7960…
Hello Chris,
We always recommend the use of SPI mode.
In theory, Parallel mode can be a bit faster as you send all 8 bytes at once, but it is far more tedious to operate.
There are no restrictions in functionality using SPI mode. Both modes allow…
as much detail as you can provide - send me email at josh.wyatt@ti.com so i can then hook you up with apps team. (i left the group a couple months ago, but still at TI and as you can see i still do care :) )
Part Number: TRF7960 Other Parts Discussed in Thread: TRF7970A Our design uses the TRF7960 in a RFID reader that is located near some high energy subsystems. In our design EN and EN2 are tied to microcontroller GPIO lines. EN2 is kept high and EN is toggled…
Other Parts Discussed in Thread: TRF7960 Hi champs,
As described in the SLOA140 TRF7960 application note (Using the SPI Interface with TRF7960), the TRF7960 uses a specific SPI configuration when communicating with the MSP430 : the SPI clock polarity…
Other Parts Discussed in Thread: TRF7960 , RF430FRL152H , TRF7970A 1.TRF7960 Evaluation Module ISO 15693 Host Commands slou312a 2.3.2 in accordance with the instructions issued command 0x21 write single block, the results can not be written, Response…
Other Parts Discussed in Thread: CC2541 , TRF7960 Is it possible to use CC2541 , with TRF7960,whille using CC2541 internal MCU instead of using additional MCU?
Part Number: TRF7960 we are doing trf7960 based security project. the main controller is pic18f452 .it configured as ook 100%,ISO15693.
but i am always getting irq status as 0x80,0x01 and 0x00 with Tag-It H inlay transponder. we used spi communication…
Other Parts Discussed in Thread: TRF7960 The TRF7960 reader's output can either be 8 ohms or 4 ohms depending on the input voltage. Should the matching components be changed when switching from 5 volts to 3.3 volts? I can only find literature on the 4…
